woudnt a flap cause power loss on the qrt5 ?

i have same issue eth1 flapping on qrt5 to the cisco sg350x switch.. cant figure out why...

flaps every 3-5 hours for 10 minutes str8.... then settles for another 3-5 hours.

thanks stop/start works, nics came back

how do you do a dude backup ?

Also is there a way to save layout ?if i rescan a new network and add to map it destroys my layout , which takes 2-3 hours to redo..

i have a nutanix cluster, i add the snmp cred's , all gets done ok, i get interfaces etc.. eth0 eth1 lo1 i add interface, then all good, for 10 seconds, with traffic, then boom interface disapears from the list leaving me with eth1 and lo1 if i select eth1 then ill get only lo1 after a few secs runn...

http://prntscr.com/gzyf70 this is receiver side SXT5ac

im getting packet losses on RX only on SXT's around 600 feet a part.

http://prntscr.com/gy5gno


Anythin i can look at ?

anyone ?

basically i hear connection drops but i can't see why it would, stats look good..

should of posted link to my snr results

http://prntscr.com/fofz5n

is there anything wrong with this ?

i have around 100-200 meters to cover and i need close to 1 gbit troughput low latency ,

curently have the sxt's in prod but i get 200-300 mbs,

what would you suggest ? Line of sight, nothing in between ,

wAP AC is good choice for this purpose.

send from my Mobile phone using Tapatalk

thanks ill try it

Im looking for a hotspot antenna to be able to server local area of 200m to 400m without getting brain cancer

got RB's 3011/2011 got a few rb951's but looking for an external antenna to be an access point to my building.

Any suggestions ?

is there another mikrotik we could use that would be able to be an antenna ? for an AP..

like making a hotspot