we have tested on a other RB and Senao AP. It works fine. So the above config is working.

The problem must then be the newest software i had updated on the rb.

I didnt succeed. Altough i can ping them from inside the wds interface. Icant get access from other interfaces. 1) I have tried diffrent scenarios, even taken the example of http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks. The latest is the following. I upgrade the MT from 2.8.27 - 2...

(my apologies - this refer to posting Setup MT with Senao SL3054CB3 Cannot communicate in WDS mode. The early mornings is taking is toll) I didnt succeed. Altough i can ping them from inside the wds interface. Icant get access from other interfaces. 1) I have tried diffrent scenarios, even taken the...

Thanks for the quick response

I make the assumption. That when i create bridge STP must be enabled.
Well i have done it. No - improvement. The problem still the same.

A lot of options is available. Use as gateway 1) Ipcop - You can use TAR (Traffic control) It sends out email daily of usage and amount availble/ spend 2) Pfsense - Free Billing solutions with Radius 1) LMS 1st one is from Alec: http://lms.alec.pl/ 2nd is from Chilek http://www.chilan.com/ Their wer...

I'm trying to set up a link between MT Routerboard 532 and Senao SL3054CB3+DX with WDS. It appears to be set up right. As the interface shows that WDS connection is made. In the Status it show that Senao AP client is connected). Clicking on the WDS it shows the MAC address of the SENAO AP. If I do T...