Hi, Check your Winbox version. To connect to RouterOS v7beta5 you need Winbox v3.21 or higher. You can still try other protocols like HTTP, SSH, ... The factory default should be pressing the reset button for a total of 5 second until LED light start flashing. Another way you can netinstall your dev...

Hi, As you stated the problem was resolved with licensing. With P1 license you are limited 1Gbps upload per interface. P10 you have a limit of 10Gbps and with P-unlimited you have no limitations. You can check the CHR licenses on the following link: https://wiki.mikrotik.com/wiki/Manual:CHR#Paid_lic...

Hi, You are using the same subnet addresses for VPN and LAN. It will not work unless you enable proxy-arp on your LAN network. The computers will not send packets to the router because the computers will think the packets arrive from inside the LAN network. With proxy-arp enabled the router can catc...

Hi,

A thread is already open about this issue. Check the link below.

viewtopic.php?t=142197

Hi,

Check the fetch command. From v6.44 they removed the "http-content-type" option.

You must now use the option http-header-field="Content-Type: xxx".


Andrej

Hi, I think you maybe have some misconfiguration on the server. I tried to setup a simple server with apache24 and php. With the fetch command I get the output to the data variable. As for the disable_ether2.php I don't know the contents of the PHP file. But as you can see I can get the output of th...

Hi, As I know is only possible to achieve bonding hardware offloading on the new CRS3xx devices. https://wiki.mikrotik.com/wiki/Manual:CRS3xx_series_switches#Bonding From the wiki page: Since RouterOS v6.42 all CRS3xx series switches support hardware offloading with bonding interfaces. Only 802.3ad ...

Hi, A simple echo should do the trick. Did you tried to run the script from the terminal window or did you run as a script with the command /system script run ? If you are running the code from the terminal window use the global variable or use the local variable but be sure to put all the code in t...

Hi, I would use binary backup only for the same device and not for transfering configuration to other Mikrotik device. Especially not if there are different models. I experienced very weird stuff after I restored the binary backup to another device. Always use export and import for transfering confi...

Please check that you have client-to-client-forwarding set to yes. By default is off. You can set it up under Datapath.