This is a very late reply I know. When we did small packages of 2mbps-6mbps I managed to setup the sector that 45clients could connect to it. I however could not maximize the 20/40/80 channel and this caused bottleneck at about 40-60mbps on the AP side. Not sure how many is possible with 100mbps tho...

My settings I currently use is as follows maybe some one does something different or can spot a mistake from my side: Band 5Ghz-A/N/AC 20Mhz scan list: default Skip dfs:disable Wireless Protocol:nv2 Interworking Profile:disabled Frequency Mode: superchannel Country:According to country Installation ...

Hi,

Would 2.4 ghz equipment not work better in your case rather then 5ghz?

Hi , I hope im not making a fool of myself but, with the netmetal ac HGO-antenna-OUT antennas will work. Are you going to put two solutions or just the one with the netmetal? If you want to beam 180 degree into a house a mANTBox 52 15s would be a good choice but not a good solution. I normally build...

I know this is a late reply but settings i use is nv2 tdma=2ms mode=dynamic downlink downlink ratio=70 Queue count = 8 qos=frame priority. Umpdu Priorities 0 and 7 enable. Queue count and qos im still testing as I have not made time to test i properly. Also havent put proper magle rules for the fram...

Thank you so much, This is great info I am also using same settings more or less.

Hw Retries: 3 or 4 I set on the sectors this and on the p2p link i put it on 7.

- Wireless Protocol nv2 TDMA-Period-Size " 4ms mine is set either 2 or 3 and working well.

All info is greatly appreciated

Great ty for the response i will change the settings back.....or atleast try a sector with nv2 and on client side any. And one sector on nv2 and client side any with rts cts last time i tested this had a bit more throughput. My MCS is set to 12 so wil look into that mybe its a bottlenek on the ap li...

Good day, I need a bit of info or direction please. With a basebox5 or netmetal when setting on 802.11 , cts to self enabled I get alot of disconnects with my clients. What I am thinking is that distance for each client needs to be below 5km that might be causing the problem. Any suggestions as with...