Are you suggesting creating a simple queue for each network and then use the WAN as the out interface? But I would also love to have a simple queue for each IP later. Doing this would make me have a complex Simple Queue table. The solution lies in creating a mangle for each network and then creating...

How can I allocate bandwidth to specific ethernet interface. I actually have four of them. Ether 1 - VoIP - Bridged with WAN - public ip (10.0.0.2/29) unlimited bandwidth Ether 2 - HotSpot - private ip (192.168.20.0/24) - 1024/2048 Ether 3 - LAN - masqueraded - private ip (192.168.30.0/24) - 1024/20...

Problem Solved! "the pigtails u.fl connector can touch a resistor near the connector and short the mpci card. Then the interface will dissapper. Please check if the pigtail is not touching the resistor (look the bad.jpg image). The pigtail should be just like in the good.jpg image." Sorry ...

Hvae you tried Neighbor Viewer - http://www.mikrotik.com/download/neighbour.zip You can telnet with it using MAC address. Also if you have the new version of Winbox.

Merry Xmas!

I just too delivery of some RB 512 Low Power and so far I have noticed that two of them does not show WLAN under Interface. What could the problem be?

Anybody has any experience on this, I dont want to open without getting approval from MT.

Thanks

Thanks guys, I would give it a shot and get back to you. If I can get 15km radius it would even be ok.

I work with a school and we have a high number of use on our network i we get 256/512 from our ISP ,when i use simple queues and gave each Pc 4/10kbps but the system couldnot browse well please what is the minimal bandwith that can cary a system thank [/i] First of all you dont need all that uplink...

Compliment of the season...

I was going thru MikroTik site and I was wondering if its possible to design a 25km radius of 2.4GHz Wifi network.

Anybody have an ideal of the hardware requirement? CPE should be any wifi radio with 24dbi directional antenna in an urban setting.

Thanks

Where do I put this? Simple Queue? Also I notice that the refresh rate in 2.9.X is slower that is when I looking at bandwidth usage of an IP address it doesnt chnage as frequent as it does in 2.8.X it doesnt look real time.

Please that didnt help, I am usign the MT as a bandwidth shapper. I ahve two NIC bridged and the IP is on the bridge. Now I have a VoIP gateway thats outside the MT bandwidth shapper, so what i want is to limit the total bandwidth that goes into the out of the the MT. 1.2mbps IN and 384 OUT. Please ...

Hi,

Please I need help on how to allocate bandwidth to subnets and also protocol. The idea is that I want to dedicate 10% of my total bandwidth to Voice. Is it possible!

Thanks

Wow! That would be a difficult one 'cause they were purchased long ago but still have the serial number which you can use to confirm the purchaser.

Also, whats the support email address?

Thank you

I did reboot.

I upgraded the software to 2.8.27 because I had forgotten the password. Now its tellme my demo has expired and has halted!

What can I do to get back my license?

Thank you

ROUTER HAS NEW SOFTWARE KEY
----------------------------
Your router has a valid key, but it will become active
only after reboot. Router will automatically reboot in a day.

It can be either Windows or Linux but Windows is prefered. Its just to authenticate MAC addresses and if possible do invoicing etc.

Thanks

Howdy,

Can anybody introduce me to any good free/cheap wireless billing software?

Thank you!

Hi,

Can Atheros radio on 5GHz provide enough bandwidth over a 25Km to transport 4 T1 trunks?

Thanks