hello, We have eBGP between multiple routers inside network on different devices: RB5009 (Different version), CCR2004. Problem with 100% core struck on proces routing. This happens randomly on different devices for no reason. When the one core is stuck at 100%, I cannot view IP routes. Regardless of...

Hello. I have setup two routers. One have rOS7 other one rOSV6. There is test bgp session betwen them. After reboot rOS 7 router BGP session is esatblished status but traffic wont start flowing and event rOS7 router dont respond for ping. After i click enabled / disabled or do refresh any rule traff...

Ofc i did. Support dont belive this is common problem. Our suspicions have been confirmed after testing the brand new CCR1016-12S-1S+ and when we swapped CCR1016-12S-1S+ to CCR1016-12G.

Hello, again. I came with new informations about CCR1016-12S-1S+. Our suspicions have confirmed. All test was done by switching new test-unit to work as main production router. Test what we have done: At start we done some test by switching between our two CCR1016-12S-1S+, problem persists at both l...

hello. We applied to @becs suggestions with RouterOS command and firmware upgrade. Hello, RB3011 Port Flapping problem is addressed by means of a new CPU Flow Control setting in RouterOS v6.43. If you have experienced this problem, it is recommended to upgrade to the v6.43 and apply following Router...

@Steveocee An older issue with lower end models was that having the LCD screen active would cause latency spikes. Don’t know if you have LCD active but may be worth a try turning it off if it is on? We have LCD screen off on both CCR's @djdrastic Sebastian , just for a point of interest . Something...

Hello. We have discovered some issue with latency peaks in our CCR1016-12S-1S+. Initial remarks: In our company we are using Zabbix (v 3.4.11) to monitor our devices. The Zabbix server is directly connected to CCR1016-12S-1S+ The CCR has RouterOS 6.42.1 (Current) The CCR has SFP modules manufactured...