Hi millenium7 and thankyou for you advice, I will try as you suggested. I suppose that in my case vlan is not necessary, right?

Hi all, I have a small network running ospf, but I need to optimize the configuration cause of a lot of messages in logs. I'm not sure on how to correctly configure all routers. You can find attached a picture showing a simplified layout of my network. Actually I run "broadcast" OSPF on ro...

just a question; now for ptp link wich is better between nv2 and 802.11n?

Mistry7, I have no experience on ubiquiti or mimosa, but it seems you are comparing not similar architecture. Even if you have all the same parameters in mimosa and mikrotik, C5C is a 4x4 MIMO, R11e is 2x2. It is normal you have a double bandwidth as in post viewtopic.php?f=7&t=136002&start...

Mistry7, I have no experience on ubiquiti or mimosa, but it seems you are comparing not similar architecture. Even if you have all the same parameters in mimosa and mikrotik, C5C is a 4x4 MIMO, R11e is 2x2. It is normal you have a double bandwidth as in post viewtopic.php?f=7&t=136002&start=...

Now the max troughput total is 80Mbps of uplink to theses others towers, before with a Sextant-G(Level4) in NV2 in the place of the LHG 5ac the traffic was 120-150Mbps... Tomorrow i go up to the top of the tower to change back to the old Sextant-G... hoping NV2 and 802.11ac work fine in a near futu...

@Normis hundreds of WISP are in trouble cause of Mikrotik new devices and no answer comes from you. We would all appreciate a few words of explanation, because to be silent means to admit the existence of big problems that can not be solved, it means to say to everyone "Mikrotik is not the righ...

@mistry7: thanks for your advisory and information. @wispman74: I think you got the problem with configuration. Lockup MikroTik wiki for how to configure PTP with MikroTik devices. Hi binh, thankyou for your advice, but this is not the first ptp I configured (tens before now), but is the third usin...

Hi binh, sorry, but unfortunately there is another issue on my bridge. For some reason I can't perform bandwidth test, ping or access winbox from the wifi side. I noticed that service ports, in Firewall menu are all red. I hope it is not a RouterOS bug, but a wrong configuration. At the moment I can...

Hi all,
I performed a test on anoter ptp link (1km) using two SXTsq 5 ac. Ther's no way to use NV2, the link drops every 5 minutes. Only 802.11 seems to work.

Hello All, as most of you I also have several problem using mikrotik arm ac devices. I'm testing a 12km bridge with a couple of LHG XL 5 ac configured to make a ptp link. They comes with ROS v. 6.40.3 and this version didn't work at all. Since then most problems was fixed in later versions, but not ...