TX rate on nRAY fluctuated between 385 a 1540 Mbit, LHG is stable at 2310 Mbit.

Thanks for the suggestions, unfortunately nothing helped, we had to replace the nRAYs on both sides with LHG. Now the link is stable at maximum rate without packetloss. It was likely a faulty unit, although we don't now which one, both directions seemed roughly the same.

This is the best configuration I managed to find, frequency 62640 with fixed TX sector. Acceptable error rate, but still not at full speed: connected: yes frequency: 62640 remote-address: 08:55:31:2D:0F:5E tx-mcs: 7 tx-phy-rate: 1925.0Mbps signal: 60 rssi: -50 tx-sector: 31 tx-sector-info: center di...

TX sectors are moving all over the place, if I force them to 31, RSSI is even better at -48, but the link performs worse: connected: yes frequency: 60480 remote-address: 08:55:31:2D:0F:5E tx-mcs: 1 tx-phy-rate: 385.0Mbps signal: 20 rssi: -48 tx-sector: 31 tx-sector-info: center distance: 208.75m tx-...

Hi, is there a minimum recommended distance for nRay 60G PtP links? We installed one at just 200m and it won't hold maximum TX rate at any frequency, even though RSSI is always around -50. At 58320 it won't even stay connected. 62640 seems best, but TX rate still rarely goes above 1540 and when it d...

*) w60g - general stability and performance improvements;

I can confirm the w60g link instability problem is fixed, I upgraded the Wireless Wire link that was the least stable on 6.47.4 from 6.46.6 to 6.47.6 and it's still stable.

I'd be careful with this one and Wireless Wire products. *) w60g - improved rate selection in low traffic conditions; is a 6.47 change and 6.47 has been terrible for 60g reliability Yes, I had to downgrade to 6.46.6, w60g links were very unstable with 6.46.7, especially Wireless Wire, but some LHG ...

OK, I sent the email.

Well, it is better than it was at full power before, but not completely stable. This is the current status of one side of the link: connected: yes frequency: 58320 remote-address: 04:D6:AA:A0:4A:0A mcs: 3 phy-rate: 962.0Mbps signal: 40 rssi: -48 tx-sector: 63 tx-sector-info: right 1.4 degrees, up 1....

One of our LHG-60ad links is only 100m long, so I had to manually set tx-power to 4 to get a stable link at the maximum rate. Unfortunately, after upgrading to latest stable firmware 6.43.2, the tx-power setting in CLI is no longer available. I tried switching to bugfix channel, but it's the same in...