Hello ArtisM, A support case is created under SUP-176902 for point 1 and 2 For Point 3 I think the IP / DHCP server dynamic entry should noted in LTE > "Passthrough Example" section on WIKI (https://help.mikrotik.com/docs/spaces/ROS/pages/30146563/LTE) Now the reading is this: "...On ...

Hi, Upgraded RBLtAP-2HnD from 7.16.2 to v7.17 this morning. These comments I want to add / ask after the upgrade: 1., not used LTE APNs can't be deleted - even if LTE1 interface is disabled. I have 3 created for test purpose. One will stay as a tested/working one. Other two APN profiles (test) can't...

Hello, Not the sam, but similar: After upgrading CCR1009 and an RB3011 IPSEC shows: "parsing packet failed, possible cause: wrong password". During upgrade there was no password change or other setting. Now I have changed a password for a very basic characters, but still the same. I see pa...

If you can replicate this behavior, best to create support ticket with supout.rif included.

Hello, I also think about it, but I would confirm the behaviour first with someone else, rather than just bump to the support team.

Hi, May be I found something weird behaviour of system /users password change window in WEBFIG. I have 3 users, only for admin purposes. First is admin (I know this name should be eliminated, but for an isolated labtest environment is ok now) Second user is test. Third is vtest. I would change the s...

Hi,
I would correct my self.
The script works well.
Precondition is to Enable and configure an Off state to the user LED.
After the setting, script runs immediately and LED follows the condition.

Thank you the help.

Hello, thank you for the tip, but this also does not work in System >Script section. If I run the script with the "Run Script" button(or a created scheduler task reaches the 60 seconds) LED not changing to on. Steady off. I have RB750Gr3 with latest OS 7.11.2. If I set the LED from the Sys...

Hi All, First of all I'm not a script-guru, so tried my best to achieve the goal to turn on USER-LED on specific case, when the route (called: test) is active. Otherwise, turn USER-LED off. Of course, the specific Route entry is commented with "test" correctly, so that is double checked. I...

I wasn't aware the S-85DLC05D could do 100M at all, and I can't find anything about it either. Same for the S-31DLC20D. So count your blessings if it works at all, I daresay. Where did you read that either SFP could do 100M? No, I was not sure and still not till I read on Mikrotik's SFP compatibilt...

Hi, strange behaviour I faced with. Installing Multimode SFP S-85DLC05D with manual speed set 100M and Full-Duplex > other side CISCO SG350 with Mikrotik SFP S-85DLC05D. Works ok. Installing Singlemode SFP S-31DLC20D with manual speed set 100M and Full-Duplex > other side CISCO SG350 with Mikrotik S...

Hello Experts, Today I accidentally deleted the USB port from the System > Ports menu and now I'm not able to reassign PPP-out interface to any USB port. I tried netinstall to 6.49.6 > did not bring back :( I tried netinstall to 7.2.1 > did not bring back :( Netinstall went through well in both case...

Hi, I just want to ask (I"m quite newbie) the limitation of the SSTP Server instances with different names? I also want to connect many customers to one Mikrotik CCR1009 with different certificates withdifferent subnets /Interfaces. Of course I would use different PPP/Secrets individually. Is t...