We were in desperate need of additional ports at one of our smaller POP's and decided to give the CCR2004-16G-2S+PC a shot to replace a CCR1009-7G-1C-1S+. We're trying - hard - to move away from Cisco but running into capacity limitations far short of Mikrotik's published test results. We perform ve...

Thanks for this thread! I got mine working on my RB4011. @Paul I had issues being authenticated but no IP Address from DHCP as well. 1. Make sure Identity and Non-Identity in Dot1x are your Gatways MAC Address. 2. Set ether1 switch port to fallback AND the vlan-id=0 . Although...it seems that it wa...

Ping. Please Mikrotik? Can we get the ability to assign a speed to a gre-interface so monitoring/reporting works correctly?

2020 and same issue. We use LibreNMS and it auto-polls the interface speed which reports back as 10mbps. Mikrotik, can we please get the ability to set a manual interface speed based on the capacity of a tunnel?

Bueller? Bueller? Is this not a common configuration?

We're in the process of (hopefully) dumping a number of L2 WAN connections in favor of higher speed Internet connections and doing GRE over them back to our Data Center. Ideally, we're looking to ditch Cisco along the way and convert these to Mikrotik. That said, we're stumped as it seems our config...

theprojectnewbie, I had all this working on IOS12 / High Sierra, however since upgrading to IOS13 / Catalina, I'm getting an array of different issues. Thinking this was related to the SAN issue you mentioned above, I wiped everything out and started over while generating SAN names identical to your...