Look at the mode setting, its says router NOT bridge as I noted to look for in post #6 above LOL. Ha, indeed. So that's the default setting, and I admittedly did not update this earlier; just went right into WebFig and did the steps as I outlined in the first post: 1) Set up security profile 2) Tur...

As to the config that looks like a default router config vice an access point config.
When you go into quickset what do you see at the top left corner.

Below is a screenshot. Seems to say I am doing WISP

FU and the horse you rode in on. Could you elaborate on that? If somebody could help without randomly telling me to f*ck off, it would be much appreciated. Not exactly a warm welcome to a new community, in the *Beginner* forum. Still, I do appreciate the effort anav put in to try and help There was...

I figured I would post my default config, just to be a reference point. I have tried a few things mentioned by anav but have not had any luck yet # jan/02/1970 00:12:02 by RouterOS 6.42.12 # software id = 5QXS-9AUI # # model = RBwAPG-5HacT2HnD # serial number = BED90A20E1AE /interface bridge add com...

More configuration information below...

Hi anav I attached the output in an earlier post in this thread, is this not what you are looking for?

I was set up with WISP AP by default as well. Has anybody had success with this particular configuration (with a non ROS router doing dhcp) that could post their configuration file? I would agree that setting up the main router to provide a preset IP to the wAP based on it's MAC address is a good id...

Thanks for the advice; I thought I read somewhere that repeater doesn't work if one of the routers is not a Mikrotik. Either way I can give this a shot.

Were you expecting the main router to provide DHCP for the access point clients? Yes, this was the idea. Here's the output of the command, thanks for the help. # jan/02/1970 00:07:59 by RouterOS 6.42.12 # software id = 5QXS-9AUI # # model = RBwAPG-5HacT2HnD # serial number = BED90A20E1AE /interface...

I have a wAP station that I have been trying to set up without success. I have been using WebFig but at some point I got the device in a bad state and needed to log using WinBox and the MAC. Then, I reset the device to its default config, after which point I can log in using WebFig and WinBox using...