That was a no go as well. It seems to not even use the rule I create even if I tie it directly to the pppoe interface (In Intrerface). The ato generated MSS rule sees 1 packet and about 44 bytes everytime i try to load a site and the rule I created (that is identical to the auto rule except for the ...

I will try that next. Thanks

How do I get it to NOT automatically create a change MSS rule when it dials up the pppoe. Currently it is set exactly 40 off my MTU and I can't change it. I can delete it but if pppoe logs in for any reason (reboot, loss of sync, etc) it will auto generate the rule again.

I tried serveral MTU settings as stated above. It generated the MSS rule automatically and I never tried manaully setting it.

The pings never stopped. DNS also seems to always work.

I will try this and post my results.

thanks again

I also tried letting the pppoe-client interface create the default route and tried setting a static route myself. The pppoe login happens to get a specific IP address so I tried to use both the pppoe-client interface and the actual gateway address. I don't recall the specifics of what didn't work at...

I tried both of those settings. I started off with pppoe-client and then when I tried a dhcp connection I obviously had to change it. When that worked I tried leaving it that way and going back to a pppoe connection and the result was as expected. It didn't work at all. Thanks for the help so far th...

Settings should be the default 1492 but I took it all the way down to 1420 and 1400 just to check that because I had a Cisco VPN router that was very touchy on the MTU once. Again, no dice.

I've got three RB450G MTs brand new. Two of them need to be set up as PPPoE clients for a DSL connection through a bridged modem. I can not get it to work. I have reset them to factory defaults and tried re-flashing them. My setup thus far is very simple. PPPoE on ether1 with ether2-5 bridged and DH...