I don' know what to say right now
I feel this same what Sob said, but from the other hand I understand what Znevna and holvoetn suggest.
Now, i'm going back to run script. Thanks to informations from Znevna and holvoetn I will do some small changes in it.
Thank you.

post deleted

OK, again it happend. But now I just disable/enable peer and connection restored.
So: I've two wireguard interfaces, both has only one peer for each interface. After power outage one is created and working well, second (using FQDN as endpoint) NOT.
Any chance to fix it?

best regards

If that works, it is a possible indication of the dns resolving problem. Which some declare a bug in ROS but can be circumvented quite easily using a small script. It doesn't hurt to apply the script anyhow. Your logging should show if it has been used or not. But at least the connection should com...

Wireguard / peer Select peer Toggle status ( disable and enable again) That's what I mean. Ok thank you! No I didn't try that but I think it might be help. I used a script for work-around to fix that issue which restarting interface (not peer) and it was working well. Next time when I lose connecti...

16 seconds to bring up the peer for the 2nd interface is kinda a lot of time. Something is wrong there.

Thank you for informations. Is there any way to check it, whats possibly goes wrong?

16 seconds to bring up the peer for the 2nd interface is kinda a lot of time. Something is wrong there. Agree. @madejson when it fails and you toggle the peer status, does it activate then ? if so, it still might point to DNS resolve issue. Are both WG interfaces defined with FQDN names or one IP a...

Ok, finally I reproduced that bug. In fact, in normally condition wireguard link looks stable. But after serveral days I lost one localization. I can connect via web so I've access to logs. There was information about power outage (router rebooted without proper shutdown, probably power outage). The...

Glad to hear that, but there is no mention about this bug is fixed. I have to set it up in my configuration and figure it out.
Thanks!

2x hap ac2, 1x hap AC3. No lose/break routing table issue at all.

Any chance to fix problem with disconnecting wireguard peer when endpoint is set by domain (not an IP)? Issue is described here:
viewtopic.php?p=914534#p914534

Any chanse to fix it? Issue exist even on the nevest firmware 7.1.3. Script with disabling/enabling peer works, but this is only work-around, not finall solutions.
Best regards

Looks like my wireguard tunnel is down after update... Did not check the details, will have to investigate later.

Mine works ok, 2x hap ac2 and 962UiGS-5HacT2HnT looks like work properly.

Is someone prepared tickets with mentioned wifi issue? I'm not so experienced as most of you so basing on my konwledge could be wrong. I hope that new release will have fixes for all problems discussed here.

Other thing: should we register tickets for every single issue mentioned here?
Regards

RouterOS version 7.1beta2 has been released in public "development" channel! Can also confirm a DHCP issues on hAP ac2: wireless clients time to time are unable to get IP address and reconnect in a loop. WLAN interface disabling/enabling temporary "fix" the problem. Also confirm...