You can run RouterOS on the r4 in a virtual machine, I tried it with the Cloud Hosted Router image from downloads, I took the "Raw disk image (arm64)" and it's working fine. I tuned my bpi-r4 a bit to get hardware acceleration with kvm and installed libvirt to manage it with virt-manager f...

By chance I found out today that the transceiver works with 2.5g, 5g and 10g! Only 1g and slower doesn't work. I always tested against one of the 1g ports on the switch and failed. It runs now on a Netpower 16p with 7.17rc3, negotiated stable to 5g. 2.5g, 5g and 10g are always shown as 10g in winbox...

7.12rc5 has changes to 98DX226S switch chip. I tried it on Netpower 16p, UACC-CM-RJ45-MG still does not work, always RX Loss detected.

I tried it right now, in Netpower 16p it doesn't work. I tried 7.11 and 7.12-beta1, It always signals RX loss. Do you have a ticket number? Then I‌ can reference it when contacting support. /interface ethernet monitor sfp-sfpplus2 # 2023-08-22 12:20:10 by RouterOS 7.11 # software id = 3VVI-W6C1 # na...

I always use the small LC connectors, they are slightly smaller than RJ45 connectors. The fiber cable is thinner than CAT7 cables, so you can put several cables in a 20mm conduit. You can even split the LC connector and put one piece a little behind the other, then the connector will have a minimal ...

I have to use 2 Cat7 cables which should carry 10gbit, one is buried in the ground for 20m, the other goes through concrete (unfortunately without conduit so I can't replace it). Those were the first cables I installed, now I found fs.com and I really like their FTTA fiber optic cables, supplied rea...

Thank you! I'm about to upgrade my home network to 10gbit, but have to use a few copper links. I started with a netpower 16p and S+RJ10, but this is running way to hot. I won't buy more S+RJ10 but wait until mikrotik releases a better sfp+ RJ45 adapter or supports the ubiquity one. This is a home ne...

Did anyone retest with newer routeros, 7.10?

Hello .... The problem of rebooting the LHG XL 52 ac has not been resolved since version 7.2 The device starts auto restart minutes after the update .. The device works satisfactorily on version 7.1.5 and below has anyone reported this? I ran into the same problem, connection working for few minute...

For the CSS106 a simple wget ist enough to backup theSWOS configuration. I don't know oxidized, but maybe you can set it up to download the backup via http?

That's too bad, this is my primary use case. Already bought two GPEN21, tried to configure them, failed, and then found this forum post. Haven't found anything about this limitation in user manual, quick start guide or your website. Please document this limitation on your website and try to fix it i...