Hello, I am looking for a simple command that will disable/enable connections to a single local IP address on my LAN. I've tried the following that I found in this forum post - https://forum.mikrotik.com/viewtopic.php?t=119019 /ip address disable [find address="10.1.10.xxx"] /ip address se...

@secret, Your Wine reg tweak was very helpful.

Thanks !

Hi,

I need a static public IP address for the VOIP server to register with SIP providers.

I think the solution I need may be something like this:
https://mivilisnet.wordpress.com/2016/1 ... rough-nat/

I have not studied this to understanding yet.

Thanks for your reply.

Could Router1 send Router2 a regularly scheduled Keep-Alive refreshing connection route info? All of Router2's outbound traffic only goes to Router1.

I am looking to change from my ISP that provides a static public IP address to an ISP that only can provide a private IP address served by DHCP. Router1 WAN: dynamic private IP from provider VOIP server Router2 (cloud instance) static public IP Forwards all traffic to Router1 > VOIP server How can I...

Hello, Thanks for your replies. I should clarify I am looking to ensure that the Internal subnet will always have the bandwidth required while the Guest subnet is able to use whatever is left over. I am hoping to avoid reserving bandwidth for the Internal subnet that may not be in use when the Guest...

Hello, I am looking for some advice/validation on setting up some simple queues to prioritize traffic in and out of my hAP ac2. I want to be sure I'm not missing anything. I have a working network with two /24 subnets, Internal and Guest. Internal is on a bridge and includes the ethernet ports and a...

Hello, I'm hoping someone can help me determine if I am setting up my router correctly. I am installing my 1st MikroTik router and have run into a problem that I think may be caused by incorrect provisioning by my new ISP. I am switching service from a large national cable/internet provider to a loc...

Thanks for your help @sindy :-)

Hello, I will be provisioning a hAP AC2, my 1st MikroTik, this week. I have not installed or accessed the equipment yet and am researching how to configure using Winbox. The setup requires admin access to a PBX behind a NAT. Is it possible to limit access to forwarded ports to specified FQDN(s)? Say...