KNOCK on WOOD, I haven't had any dead r52h's yet or any that have failed me in the field.

I changed radio cards out and it stopped so far.

The biggest AP I have has about 47 users on one sector running PPPoe with MPPE128 stateless. I run 2.4ghz b/g on this 90 degree pac wireless horizontal sector with an engenius radio card at 400mw. I have customers down in the -30s ranging up to the -70s on signal wise. I have been doing some researc...

I would like to know also, I have several rb532's like this and a bunch of 133c's that did this and one 411 that did this same thing. The ether1 port is just dead.

This started happening to me this morning. Any ideas?

Why do you guys say they are garbage? I've had a pretty good experience with them. They are 400mw and i've had a few 600mw also. the 52's i see are only 100mw and the h's are 350. EMP-8602s 600mW a/b/g Mini PCI Atheros is the 600mw card at 52.00 bucks is cheaper than 69.00 at the h with almost twice...

Guys, I deal with Canopy's all day long everyday. I hate them damn things. Yes they are good at making a lot of noise. But, I am on a water tower and I am coexisting with them just fine. The 900mhz system I know for a fact won't do anything against my 2.4ghz equipment but, the 2.4 ghz canopy equipme...

Can anyone shed some light on this? Has nobody tried it? How about you Mikrotik guys at Mikrotik?

From what I have learned about interference. I have spaced them out as far as I could and still sometimes I have to put them closer together to get the right amount quality. The signal's might be a little worse but the quality is there. I have a lot of a few providers in my area that are using canop...

my problem with that is my ends were not put on correctly. had a faulty set of crimpers.

I'm looking to see if anyone has attempted this how it worked. Will have a rb600 with a 604 daughter board. I will put 4 engenuis 400mw cards used as two backhaul's with nstreme2 running dual polaraity dishes then on the daughterboard i wish to put an additional 3 engenuis 400mw cards to put up 3 pa...

i used various kinds, i've tried simple queues and queue trees..

you need to add in mangle rules to mark the connections and then use the connection marks to determine which one you want to go out where. Edit: after re-reading your post again for the third time, your not even close to the right path. you need to make nat rules and mangle rules and add routing rul...

Ok, I have three 90 degree pac wireless horizontal sectors two rb532a one 532 is running two engenius 400mw cards connected to sectors with 3 feet of lmr400 ufl to female to the radio card. the other 532 is running on sector with a 400 mw card and the other 400mw card is running 5ghz as a backhaul t...