We would like to share some of our findings using the new R52N cards. The setup is RB300 and RB600 with ROS4beta3, 1 dishantenna at each point. For about 2 years now we have used R52H cards, and gotten a good speed ~25mbit TCP on a 4km link. (2.4GHz turbomode) Last week we got 2x R52N cards, and ho...

Does someone have any answers to this, or some data they made on only 1 rx/tx chain? This was answered before. You need to connect TWO antennas to the N radio card, not just one. If you only have one antenna on each side, use the R5H in turbo mode instead. You do not NEED to connect two antennas. Y...

We would like to share some of our findings using the new R52N cards. The setup is RB300 and RB600 with ROS4beta3, 1 dishantenna at each point. For about 2 years now we have used R52H cards, and gotten a good speed ~25mbit TCP on a 4km link. (2.4GHz turbomode) Last week we got 2x R52N cards, and ho...

We would like to share some of our findings using the new R52N cards. The setup is RB300 and RB600 with ROS4beta3, 1 dishantenna at each point. For about 2 years now we have used R52H cards, and gotten a good speed ~25mbit TCP on a 4km link. (2.4GHz turbomode) Last week we got 2x R52N cards, and hop...

Hello. I run the dude on my rb333 with no problems, but when i use the dude on my rb133c it runs for a short time and then the rb133c crash. Then i have to shut down the dude and wait 5-10min before the rb133c starts up again or i have to do a power cycle. When the rb133c crash, its also lost in win...

I would like to contribute with a danish translation to this fine free software.

Is anyone else doing danish all ready, would be nice to know before i start?

Regards
Brian

Hi all. I have a few wrt54g´s on my network, and found out i can pull wlan signal levels from it via snmp. My problem is it dont update the signal level, only when i manual do a snmpwalk or in another way reload the entire snmp list from the wrt54g. One of the link labels looks like this: Signal -[o...