R52 with RB133 has been working great since 4 months 24/7

I have set it on 18dbm for some time. It's working OK so far.

I did a mistake of replacing 3x120deg sectors (indivdually fed with 2xr52 and a XR2 on rb532) with an 15db omni antenna and im desperate right now :( if you want peace of mind, good quality signal and stability, do NOT ever go for an omni.. pay a few more bucks and go for individually feeded sector...

I'd suggest to go up with a test system and just check the noise floors to see what what they say just to make sure. It's better than doing a huge install just to find out it doesn't work. If it were me, I'd probably go with an XR2. If not for the higher output and good receive sensitivity, because...

Omni sucks...

Sure

in a perfect theoretical situation, sure, it'll work just great. Realisticly, 10.5 dBi pushing 200mw with a 24dBi grid for a client got me 5 miles on a test shot. With MT, it would have been a stable signal. It still would have been at the absolute edge of stability, but it would have worked. Sound...

That's a loaded question which there is no good answer for.... In a wide open area where there are no trees, hills, or buildings in the way and there is no interference... yes, it is possible... In a big city or forest, probably not chance of it. Also depends on the clients' transmit power, antenna...

Hi

If I use RB133 with one R52 wlan and one 15 dbi omni antenna with hotspot enabled..

How much coverage will I get?

I want 12km max (each direction)

What about stayability?

Dual nstreme is full duplex. The only way to acheive true full duplex is with two pairs of radios. Also, I saw at one of the MUMS, Butch Evans showed that full duplex can also be achieved with non-nstreme via two pairs of radios by using OSPF and path costs. Looked real interesting, it transmitted ...

Done without bridging wlan1 & ether1

the IP doesn't have to be in the same range.

I'd like doing so, but can't tell now

Thank you very much All done perfectly, IP assigned by the modem and internet connection is fine :D The modem gives IPs for clients.. not the wlan1 This is a video on how to configure the mikrotik router as an AP for 3com modem made by one of our guys: http://www.4shared.com/file/23082027/141cebfe/a...

Having RB133 with 1 wlan (R52) connected via cable to 3com adsl modem How can I configure the 133 to work as an AP for the modem? I did these settings (dns, dhcp server/client, hotspot,users, wlan mode= ap bridge) I can connect to it wirelessly but no internet access also, how can I assign an IP for...