Hi, sorry for not getting back to you. export from central router: # model = CCR2004-16G-2S+ /interface bridge add dhcp-snooping=yes name=LAN-bridge port-cost-mode=short add name=dockers port-cost-mode=short /interface l2tp-server add name=REMOTE-3_L2TP add name=REMOTE-1_L2TP add name=REMOTE-2_L2TP ...

OK, so I have set up a S2S IPsec VPN over L2TP. I have a central site and have two branches. Central site can access everything on the remote branch sites. Remote branch sites can reach and access central site. Remote branches can not "talk" to each other. I am using static routes and all ...

But I can see the requests in the new PiHole which is really strange - my DNS cash is not filling up in mikrotik Which DNS IP address clients receive? Assuming that is set over DHCP, not manually. Possibilities depending on client's DNS IP: DNS IP is of old Pi-hole and that Pi-hole in configuration...

So I have 2 PiHole servers running. One is on my 2U server and is currently active. Once I set a new IP of the new PiHole that is in docker in Mikrotik, DNS is now working for the clients. But I can see the requests in the new PiHole which is really strange - my DNS cash is not filling up in mikrotik

OK, so I finally got the container working on my new CCR2004 :) The problem is now that when I switch from my current PiHole which is on my server to this new one on container, I can see the traffic on new PiHole container. (I can access the GUI at 172.17.0.2) But my mikrotik can not ping 172.17.0.1...

Based on the image you've shared the partition name is "disk1-part1" (check the column FS), hence your commands if you followed this guide should look like: /container config set tmpdir=disk1-part1/pull /container mounts add name=etc_pihole src=disk1-part1/etc dst=/etc/pihole /container m...

Just out of curiosity can you rename the USB disk to Disk2 or USB or something like that and use that label for your pull directory and container location?

tried but still the same problem :/

There's no filesystem on it. You need to create an ext4 partition on it.

You were correct, I removed that USB and reverted back to the 16 GB one, formatted to ext4

here is the situation with the new stick, but the same problem:

Disk1 is the flash storage of your RB3011. Go to System --> Disks to get the path of your USB You will likely need to change your tmpdir location too. For example here are my partitions running on 7.8Beta3 - you can see usb-part1 is the partition of the USB Key if I were to use mine for storage. Al...

Hello guys, I have been following YouTube videos from Mikrotik in order to install a container with Pi Hole . I did all steps as asked but I get an error that there is no space to extract layer... at first I tried with 16 GB USB storage, changed that out to 64 GB and I still get the same error. I ha...

Hi all,

I have the same problem but the problem introduced it's self. I had it all working and no configuration was changed, nor any HW with which I connect...

Also would appreciate any help on this.

btw, my remote Mikrotik is using a lte connection