Please, close as I can't delete this thread. Upgraded again straight to 7.14beta3 and it works now... I stay puzzled, but I can't debug it any further.

Hello, I can't manage what I'm doing wrong with this one - it just silently exits on the ":local result (/tool fetch..." call without any error when called from WinBox "Run script" button, or scheduler, but works otherwise fine when ran from terminal. This is the behavior under 7...

I gave up with repairs for a while - with no documentation it is usually unfruitful. But today I needed it for some quick tests in the field and I gave it another chance. Of course, the device did not repaired itself. I measured again all the transistors involved in PoE out switching and the interes...

Turns out this was fully correct and "solved" my problem with the hEX S. Leaving the device unpowered for 10mins brought the PoE out back to life... Glad it worked for you. Unfortunately, in my case, did not help at all - I strictly followed the procedure and PoE out is still dead. Even d...

Thanks for response. Earlier I tried powering it from Ubiquiti 1 amp 24v passive PoE injector and 800mA DC power adaptor bundled with the device. I just tested with lab power supply set to 5A limit - device powered up properly consuming about 75 mA, but the PoE behavior is the same, broken unless to...

Replaced U1000 with TI's LM339PWR, the device behavior is the same - once powered, PoE out don't work, unless touched U1000's pin 1 with anything, or some resistors (in the R/C set of 8 on the right from U1000), touching another one from the set breaks it back. I suspect some of the transistors, tho...

Ok, there is something wrong with PoE-Out on RB951Ui. The DC+ pair of ether5 is floating at ~6V (decreases under slight load) and not driven anywhere by router regardless of ether5 poe setting (off, force on). First, I followed the overvoltage damage manual and checked: - terminating diodes - all 75...

Hello, This is my first post here, so please move to relevant category if this one is unsuitable. I'm trying to power up mAP lite connected to ether5 port of RB951Ui-2HnD powered via 24v passive injector on ether1, also tried powering RB951 via DC jack, no luck so far - the mAP lite does not power u...