Did you succesfully import the certificate that is used? Anything in the log that might give an indication? Does it work if you (temporarily) disable certificate check? Can you also check if https://1.1.1.1/dns-query does work? Yes, the certificate imported fine. https://1.1.1.1/dns-query returns a...

I have the same setup without issues.
Here is the Starlink WAN port config:

I'm on RouterOS 7.8 on a Mikrotik I configured DoH on my Routerboard as per the instructions here which seem logical: https://www.medo64.com/2021/08/dns-over-https-for-mikrotik/ The process seems to go fine, but for some reason when I visit https://one.one.one.one/help/ it reports DNS over HTTPS is ...

That will be hard to avoid (the double-NAT) unless you have extra public IP's and can ROUTE some traffic up to his WAN-port. I just want him to be on my LAN via his router's LAN switch, while preventing access to the systems on my LAN via that cable. OPTIONAL -> If you & the neighbor can agree ...

Take 1 interface out of the bridge and put a small subnet on it (eg /30) ? Then have the cable run to the neighbor and let him config the correct IP on his "WAN" interface. Secure what needs to be secured with some FW-rules (eg. make sure the "connection subnet" /30) cannot conn...

First: Dont understand why you play with WANs turning off an on manually. What is the requirement that drives that........ Why not primary secondary tertiary OR load balance between all three, or some combination???? It would seem that the requirement in terms of neighbour connectivity is PRIMARILY...

Thanks @spippan, is there a preferred approach given that I might in future want to apply some QOS or speed threshold rules?

I have router OS 7.8 on an hAP ax3 I have two WAN ports, 3 LAN ports and a single bridge. I manually enable / disable the WAN ports when switching between internet service providers. I want to connect my neighbour's router to one LAN port and isolate it from the rest of my LAN, but allow WAN routing...

I believe you can use netwatch to switch WANs and in there you may have the opportunity to have some flexibility...... ?? Thanks for the response, Netwatch looks fascinating. This is my first foray into Mikrotik devices in around 10 years so I have some reading to do haha. Thanks again, I'll post i...

I have ROS v7 on my device with the following connected devices: ether1 - WAN1 (LTE) - distance=1 ether2 - WAN2 (Satellite) - distance=2 ether3 - LAN bridge ether4 - LAN bridge ether5 - LAN bridge Right now, recursive route failover is working superbly. If WAN1 fails, within 20 seconds (2 pings), WA...