Hi Sirbryan

I understand this is quite a late response to what you said above.
Can you please elaborate more on what you were saying

Hi all I have an issue with my newly setup Mikrotik CCR2116-12G-4S running 7.13.2 We are in the process of setting up an unmanaged internet connection as part of that we advertise our two /24 ranges via BGP to our ISP One range for customers and one range for company use. We plan on breaking up the ...

Setting my VRRP ip as /32 allowed me to progress further

Good Morning all I have two Mikrotik routers running a vrrp for our range I have the vrrp setup as this 192.168.0.1/24 and the routers themselves are .2 and .3 in my arp table I see two entries for each IP, One being the VRRP and the other Ether1 with the same mac address across all I am attempting ...

Good Afternoon all I am hoping for some advice I have a unknown to me issue i was hoping for some assistance with. I have a cluster of mikrotiks C2116-12g-4s each peering with a different ISP, We advertise two ranges x.x.x.0/24 on the mikrotik i have setup a vrrp with a /29 network in this range x.x...

i think i really did sort it this time, let me pre-empt this by i am very new to mikrotik and this is my first router setup. I had Pre-emptive mode setup on both Main and Backup. I believe this was causing Backup to try be main I now have it setup only on Main router not on backup router and so far ...

Hi all I am still facing this issue I have two Routers setup with VRRP After approximately 4H30min my backup router becomes the master the only thing in my logs are vrrp,info VRRP-94Range now MASTER, master down timer in Router2(R2) Which causes my internet to drop if i disabled the interface the Li...

Hi I have two CCR2116-12G-4s I have them setup with VRRP and most time this works fine But occasionally Router 2 (backup router) becomes RM while Router 1 stays RM This causes internet drop outs. Restarting R2 fixes this issue. How can i make it stop? If you need more information to assist with the ...

Hi all. I have now configured my two Mikrotik CCR2116-12G-4s+ I have a IPV4 + IPV6 EBGP session setup with my ISP. I have 3 VRRP's (currently shared between the two devices and the failover on them works as expected. However when i disable eth1 on R1 R2 ports become master But it takes up to 1 min t...

Thank you all for taking the time to reply.

It has cleared up a lot and showed me a path forward.
I will definitely be back with more questions.

thanks again

Hi All Is it possible to have one ISP 1gb connection and setup the bgp for it on 2 mikrotik CCR routers. We are thinking about redundancy and would like router 2 to kick in if router one fails for whatever reason via VRRP How can i achieve this Secondly we will eventually have a 2nd failover Line So...

Thank you for the confirmation

I was going to Do VRRP on the LAN Side.
I put mislabled my basic diagram.
thanks again

Hi All I am after some guidance or a push in the right direction The company i work for is moving away from managed internet. We are embarking on the unmananged path. What we have is two WAN links a main and a backup. We have acquired two CCR2116-12g-4s+ Is the below a viable HA solution Currently m...