So the "bridge" which kind of roles plays usually? bridge functions are used when two wireless devices "bridge" gap between two wired islands. One device us "ap-bridge" and other device is "station-bridge". There are variations of the setup, but roughly this ...

cAP AX (the last ones I saw) come default with 7.8 out of factory if I am not mistaking. IF you are using capsman, you need to upgrade to at least 7.10. (7.8 did not have default caps mode for AX devices, 7.9 is buggy as hell w.r.t. wifi). Then reset to caps mode or default mode, as needed. Quickse...

You're using new wifi driver on cAP ax. Which has most options reworked. Mode "ap" supports what "ap-bridge" did in old wireless driver. One question: how do APs (cAP ax and older cAP acs) connect to router? Wired using UTP cables? If that's do, then the "bridge" part ...

Hi, in my home network i have a RB750Gr3 as router and several RBcAPGi-5acD2nD as wifi spot configured in ap bridge. In this way all my home devices (wired and wireless) are in the same lan subnet. I just bought a cAPGi-5HaxD2HaxD for adding a 6g wifi in the pool, but i discovered that it has not th...

Following you indication I created two different wgs with two different internal subnet as assignment and then I created the two firewall forward chain. An additional question: as source address and dst address i can use a /xx for defining a subrange of IP? So i do not need to duplicate the rule for...

The mT is fully configured for a ppoe connection and there is an internal LAN. I already configured one wireguard interface correctly for remote access to the LAN and even for the mT configuration. I created an additional wireguard interface (working) that I would like to restrict only for reaching ...

Hi,
I successfully enable a wireguard vpn connection.
I would like to restrict to a single internal IP (actually after the connection i can freely access anywhere inside the lan).
How I should proceed?

Thank you