Dear Sir,

For masquerading packet from your local network , you can setup a new rules from IP firewall NAT . TIA

Best Regards,

Ojie Nugraha

Dear Sir, I think you might face interference problem in 2.4 Ghz surround your client links, i suggest try to change polarity antenna to vertical or diagonal polarization and configure data-rate lower than default , configure manual tx-power higher than default, maybe it could raise your overall CCQ...

Dear Sir, You should try to change the Basic Rates A/G 6 Mbps only , and the Suppport rate a/G choose 6,9,12,24 Mbps , then let see the different . In my opinion if you configure basic rate and support rate with the same value 24 Mbps, then your client CPE working so hard to gain potential best rate...

i think the best hardware retries cant use exactly same like default, according to client who's various level, ranges and position associated to one sectoral antenna , i advice you can separate the short clients into PtMP with sectoral 2,4 Ghz and the long range clients into PtP with grid 5,8 Ghz fo...

you must trying bandwidth test running first also ping to remote routerboard or pc, then you can select sent, receive or both while you can see if traffic download / receive running well then if sent not running and the ping is request time out ,,, so i think you must configure wireless channel and ...

yes, i hear sound or beep twice, i try to power on without mini pci, but both LED on eth still blinking and when i touch the surface on ethernet is very hot !! . TIA

Regards,

Ojie Nugraha

i dont know what exactly the problem , but you can explain the detail wireless configuration of your exisiting PtP , what's type of abnd / frequency do you use, what version of RouterOS do you use , is it possible link PtP have Line of Sight / LoS or not? . If u want to increase tx/rx or greater ups...

Dear Sir , We have serious problem while we're begin to setup a couple new RB 433 with 1 WMIA-166A mini pci, 1 PoE , 1 adaptor 24 volt, suddenly it boot with the green and orange LED on ether1 or PoE , ether 2, and ether3 blinking all together we don't know what's going on , then we check the winbox...

Ok, it's confirmed my problem resolved now, we change main wireless bridge into 5 Ghz and the rest AP bridge still use 2,4 Ghz, about country Japan selection and ch 14 because still too many interference in ch 11 - 13 and we gain best fit signal and data rates for our clients.TIA Best Regards, Ojie ...

Dear sir, I have problem about wireless connection, we have +/- 50 clients using jaht wp-4001br as station and connecting to a rb600 as ap within RouterOS v 3.20, our question when we see in registration tables all clients that registered suddenly disconnected to the ap and then connected again seve...