Alright, Thanks for the info. I'll try this in the office tomorrow, one more question on the client side, and if set to station mode: 1. Do I need to set an IP address for the wireless iface? 2. Or, I set an IP on the Ethernet side only and bridge it? (Cause I tried that but I was unable to ping it ...

Level 3 provides you with mode=station-wds and mode=bridge, that could be used to establish WDS link. Ok, I have upgraded to Lever 4. Now I have AP enabled, how do I maximize my SR5 output power? I'm getting an extreme low signal indoor with 23dbi antenna, so I'm guessing I'm running on a low power...

Make sure it is not possible to use WDS, since mode=station does not support bridging due to limitation of 802.11 Use this configuration example, if MikroTik RouterOS is used as access point, http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks There is another mode=station-pseudobridge ...

Hi,
Can someone provide the needed steps on how to get this configured as a station with bridging mode?

Nevermind, it was my laptop ethernet problem. Thanks for the help

Hi ashish,
winbox doesn't detect its mac address, and it times out when I enter it manually. I'll try another board that I have, btw, what is the default username/pass?

Hi,
Is there like a default IP in order to allow me to configure? or need to use serial? I was told by my vendor that routerOS is already pre-loaded tho'..

Thanks.