You may think that but Mikrotik is often forgiving and will allow traffic to flow until it does not and you trip over some errors in the config. By the way your naming convention for Wireguard was very confusing. You called the wireguard interface on the public IP router wg-lte and you called the w...

I've managed to get it working,using the following configs Wireguard on R1: Allowed Address: 172.22.1.2/32, 10.10.0.0/24 Routing and NAT config On R1 it's just a simple dst-nat to R2 LAN IP /ip firewall nat add action=dst-nat chain=dstnat dst-port=1111 in-interface=pppoe-out1 \ protocol=tcp to-addre...

Need to see config for BOTH routers. Sure I've combined them into the same code block. # 2024-05-14 23:12:31 by RouterOS 7.14.3 # # # model = RB960PGS # Router R1 /interface bridge add admin-mac=<Redacted> auto-mac=no comment=defconf name=bridge \ port-cost-mode=short /interface wireguard add liste...

One question needs to be answered. Is it important to you that the originating external WANIP is seen at the server at the second router? There are two options a. receive the incoming external requests from WANIPs, sourcenat them to the wireguard IP of the first router, send them to the server at R...

Hi everyone, I'm having some trouble setting up a port forwarding over a wireguard tunnel. Here's my network diagram https://i.imgur.com/bX6pg1m.png Router R2 is connecting using an E3372 LTE dongle that has no public IP, I would like to use public IP from R1 and setup a port forwarding rule, so I c...