Hi Hi anav,
thank you for your time and detailed hints. I will work thru them.

Wish all of you a nice weekend.

Ok, i'm online. Here is what i did: Switched off POE on Eth1 ran terminal prompt from rextended filled in ppp0e-wan username and pw had to configure DNS, because of resolve error when trying to update upgraded to 7.17.2 reseted configuration Switched off POE on Eth1 Disabled Ipv6 Disabled IPv6 Forwa...

Thank you, you answered my question perfectly. I initially thought it would only show up, when there was a problem--> loop.

Ok, i think airbags are really usefull.

Still, is the protocol shown on torch, because it was active? What causes network loops? Could it be an hint to misconfiguration?!

Thx

Ok, i will do that first. Thank you!

Hi Hi kowal, thx for the reply.
When it pops up, does this mean that loop protect was active? What is causing this? And should i avoid it.
Thx in advance.

Hi Hi rextended, first of all , thank you for your reply and your time. I got dual stack, so IPv6 is supported. I got a dynamic puplic IPv4 address( which was a true fight to get), when i used IPv6 for testing my isp downgraded me to ds-lite instantly. So i'm not sure if i am willing to risk to acti...

I tried to use the doc to solve my questions on my own, but i really struggle. I know it may be silly questions, but i would really appreciate the support.

Hi Hi ,

what is ethernet protocol 9003?
I can´t find any information about it.

Hello forum folks, i just ordered a Hap ax³ and i am looking for some help. The Hap will be connected to VDSL2 modem. The ISP is 1&1 Versatel. They use ppp0e with vlan7. So here are my questions: 1.How do i setup ppp0e with vlan7 correctly? Can i use the Quick Set? 1.1Is the default firewall set...