http://217.197.138.54/map.jpg The first box is linux router which route two networks.The clients are from one ethernet network and there are two virtual interfaces on the router (192.168.0.1, 192.168.1.1 ).I want the traffic between two networks (192.168.0.0/24 and 192.168.1.0/24) to be routed by m...

I saw . it's my icq - 156122420
By the way the router is still working

offtopic:
aviper,ako imash vreme pishi mi na icq-to.

Today,when the computer crashed again I went to the other computer and when loggen into MT I saw that the two routers were linked,but when i tried to ping the another antena's IP received only request timed out.So it's look like that the computer not crash,but there is some problem which i can't re...

Today,when the computer crashed again I went to the other computer and when loggen into MT I saw that the two routers were linked,but when i tried to ping the another antena's IP received only request timed out.So it's look like that the computer not crash,but there is some problem which i can't res...

There are two statitions with Atherous 5213 cards and MT 2.9.2.They work linked from 3 months.The first one have never been crashed,but the second may work maximum 1 week.I have changed everything which can be change but the computer still crash.Anybody whith the same problem or may khow how to fix ...

First I want to try make connection between both cards which are not linked now,but i can't.Is there problem if there are other two cards which are already connected?

Power supply - 350W
CPU - Athlon 1200MHz
RAM - 128MB
Mikrotik 2.9.2

There are 2 routers with four Atherous 5213 cards.Two of them are linked point to point in bridge mode with NICs.I want to set up and connect other cards and after that to establish nstreme-dual with all.Is it possible to do that,because i had no success in past 2 days in connecting...?

Like Eugene says you must have the IP address bound to the bridge and none on the NIC

I have already done this but with no success.Any other ideas?

It is not important.I tried without any ip addresses and with ip address on bridge,but there is no change.Is it possible to be hardware problem,because when I disable and enable ether1 after reboot bridge start work?

I have installed 2.9.6 but the problem still exist.Here are my settings: /ip address add address=10.10.1.1/24 interface=ether1 /ip address add address=10.10.1.2/24 interface=ether2 /interface bridge add disabled=no name=bridge1 /interface bridge port set ether1,ether2 bridge=bridge1 Is there somethi...

I set up 2 ethernet cards in bridge and everything work fine,but when the system reboot the bridge don't work.I fix it with "/interface disable bridge1"
"/intreface enable bridge1".Sometimes bridge stop work when the MT is running.I use Mikrotik 2.9.2.