http://foto.inbox.lv/albums/litcha/MT/huuh.jpg

In this week three routerboards have been hanged up! Maybe because of -30°

I will try to find that screenshot! I can say that it happened twice.

cm9 cards!

shit happens. What if serial port also is disabled?

I had same problem. Maybe try another ethernet port! I had problems with packet loss two times, when I used ether1. Then I made a hole into Routerboard's case and plugged into ether2 and everything worked fine. I think it's because of PoE or maybe standart ethernet chip is worse than VIA which is un...

I have also seen many strange things with routerboards.

Have tried both b/g and only b! Maybe because of power? cm9 has 65 mW and cisco 350 has 100mW.

yeah, I have tried also 2.9.6 and 2.9.7

Before it was cisco AP, everything worked fine except speed, cause 16 clients hanged on it. Now there is routerboard 532, cm9 2.4 GHz, same 15DB omni. Some clients cannot connect at all. Clients have MT routers with cisco pc cards, d-links and linksys. Just 8-9 clients are working normally. I cannot...

Sometimes I have problems with frequency list. Winbox shows 2429 and so on. Only when I am setting in terminal I can change it.

No, only real 5 GHz parabolic antenas 30DBi!

In this area I am the only one who uses 5 GHz frequency. There are not other ISP.

Does anybody knows what might be the problem! Two 532 RBoards with Atheros 5213 cards in low distance scan each other but at 3 km distance not! I have changed cables antennas - the same problem! Only when I changed value in scan list from default to default,5220 that I am scanning in that frequency ...