can someone post their config?

I am trying two SXT lvl3 PtP , got the connection up, but can't get more then 30Mbps Either Direction.

Distance is 500 Feet.

after finally re-configuring everything, i am happy to say, in lamens terms, I can get a stable 60Mbit Symetrical TCP Connection between to RB1000's with a temporary Hardwired 100Mbit EtherNet Link.

i also worked around the problem as well (used a L2TP tunnel over IPSEC, and then I also setup RIP between the two RB's, working pretty good for now)

I have given up.. Now they say they are using 4 routerboards to do the test.. I am not going to go buy 2 more rb1000's.. Last Response: Hello, R3----R1---[ipsec]--R2-----R4 R1 and R2 are RB1000 running ipsec R3 and R4 are mikrotik routers Configuration I used, and was unable to get 300MBps 1500byte ...

I was told they are "Looking" into the problem...

Thanks, To bad IPSEC traffic couldn't be seperated in the chain. or add a "ipsec" flag to the pre-filter rule or something... wishfull thinking, probably gonna have to stack two rb's on each end.

I completly redid the tests. udp test, no ipsec, using jperf bin/iperf.exe -c 10.0.0.10 -u -P 1 -i 1 -p 5001 -l 32K -f k -b 200M -t 10 -T 1 ------------------------------------------------------------ Client connecting to 10.0.0.10, UDP port 5001 Sending 32768 byte datagrams UDP buffer size: 8.00 KB...

I used two new IBM ThinkPad T61's, and two NEW RB1000's, and used iperf in TCP and UDP modes.. Never got over 150mbits, turning off ipsec, and it shot up to 500mbits..

anybody have any ideas?

nobody?

I setup a IPSEC tunnel between the Public IP of two Router Boards I then setup an un-encyrpted L2TP between the two Router Boards. If I torch to Public ethernet port , I see "IPSEC" Traffic. (no L2TP udp/1701 Traffic) If I setup a filter rule to drop all traffic EXCEPT for the IPSEC traffi...

well, i am kinda upset over this.. The fact they SAY it will do it, but it doesn't is kinda misleading.. Last I checked, Agilent Test Equipment can't measure squat, I had a Circuit that would test "fine" but it turns out, would perform worth a beans, the provider then stopped using there A...

ok, did same "test" without using the L2TP Tunnel, (bascillay uses the IPSEC Tunnel by itself) using the build in "Bandwith Test", max Send/Receive is 146Mbps. UDP on the other hand aveages 350Mbps TX, 350Mbps.. ipsec "export" [admin@OnSite] /ip ipsec> export # jan/01/1...

So, After testing, and more testing, and more testing, the MAX speed I could get over ipsec was 125Mbps... Since Version 3.20 they state the RB1000 can now do "500Mbps" using IPSEC .. I would like to see the samples used for this test.. becuase I can't get it.. Test Procedure: Tools Used: ...

I am guessing this STILL isn't fixed?

I just bought two NEW RB1000's and this doesn't work...

I need to setup multiply polices using the same peer, and only one of the polices works..