I know how to do a scan but the type of security is not included in the output.

I am looking for a way to scan from a wireless and discover the available access points INCLUDING their security type (WEP or WPA)

I have followed these instruction but cannot get it working. http://wiki.mikrotik.com/wiki/MikroTik_router_to_CISCO_PIX_Firewall_IPSEC I have also tried to get the tunnel up between the Mikrotik and a Linksys RV042. I can see the Linksys sending broadcasts to the Mikrotik (not with the Cisco) but th...

Sorry - I cannot seem to find the step-by-steps. Can you send a link? Thanks

I am trying to configure a Sierra wireless card installed in a RouterBoard 411U and am not even sure where to start. I do not even see a new interface show up when I install the card. Anyone have experience with this?

When you say network ID, do you mean same IP address? If you have specific setup instructions it would be great. Thanks.

I have a RB433 and want use it as a WAP. I am using winbox.exe to configure. I do not want to route traffic. I want to have ether1 on the same network as wlan1 - 172.16.0.0 I have the wireless set up in ap-bridge mode and can connect to it from a laptop just fine but am unable to ping either the eth...

This worked and I did not need the others posted by clarkstyx.

"ip firewall nat add chain=srcnat action=masquerade out-interface=(choos your wan interface hear.)"

Is this needed because I do not have a route from my next hop router back to the Mikrotik router?

Thanks

I could use some help configuring the router for basic internet access. I am using the Winbox.exe GUI for configuration. Here is what I have done so far: 1 - Assigned Eth2 an IP address and set up the DHCP server to assign address on this interface. This is working fine and clients are pulling a DG ...