Hi, I'm new in routeros. i need some help to configure my routeros. I have 8 wan connection with equal upload and download. I want to make a good load balance. My local network ip blocks are 192.168.11.0/24 and 192.168.12.0/24. So basically i need: 1. load balance 2. standard upload and download li...

Hi, thanks for reading this and I hope someone can help. We have a multi site set up with 6 offices connected by VPN using 450G Roouter Boards. Everything works really well apart from one site which runs an application which authenticates to a SQL server ate a different office. Every other site can ...

Hi, I have a routerboard which is currently dialing 2 ADSL internet connections - each with a single static IP address. I have configured the LAN devices to use ADSL1 for it's gateway and if this disconnects to use ADSL 2 which works really well. I have also a /28 range of IP adresses which are rout...

Hello and please excuse my ignorance as this is the first time I have attempted this. Here is my problem.... I have just bought a RB433 and 1 R52 card. I assembled the until and upgraded to 4.3. Should the card show up in the interface list along with the 3 ethernet ports? I cannot see any evidence ...

Brilliant, thank you - it worked just fine (I had to specify TCP).

Nick.

Hi, I have a routerboard 450 and have restriced all access to it in the IP Service List to all but my public facing IP address. I sometimes need to access it from a different IP and my question is, how do I allow more than one IP address to access Winbox, SSH, telnet etc? Many thanks in anticipation.

Thanks Nick. I'm just struggling to grasp the concept that the Firbrick uses which is the pseudo address. I.e. I want the Pix to have X.X.X.9 (from my /29 block) as it's gateway...... am I right in thinking that it's as simple as assigning this address to one of the ethernet ports and then another I...

Hi, apologies as I am new to this so please bear with me as I try to explain...... I have 2 ADSL internet connections from the same ISP. I have a block of IP addresses which I can route down both lines. I have a LAN network behind this on a private IP address range (192.168.16.0/24). What I would li...

Hi Guys, Good news, I have figured out the problem. Basically the 2 networks had different DNS servers so I added them into the DHCP server settings and it worked fine. Thank's for your help with this. I am going to try something a little more complicated now so no doubt I will post another question...

Hi, many thanks for that. As I say, this is all new to me. I have tried what you said and applied the following; /ip route add gateway=81.187.113.1 check-gateway=ping /ip route add gateway=10.40.1.1 distance=2 However, it seems to have stopped all internet access now to either network. Apologies onc...

Hi, apologies if for my basic knowlege but I am looking for some help with the following. I have just bought a RB450 and it is the first time I have seen the OS. I have managed to connect to it, assign IP's to 3 of the interfaces in the following configuration; eth01 - 192.168.1.1 - this interface p...