Mike,

Does yours show up on 10mhz and 5mhz?

When I do a scan from the remote side it doesnt appear but as soon as I switch it back to 20mhz shows up straight away.

Cameron.

Same here. 20 MHz cahannels work fine. Fractional, it sees nothing.

Mike

I am using dynamic WDS. The link works just fine with 20 MHz channel width. Just can't see it when I switch to 5 or 10 MHz. I think I have everything set right, otherwise I wouldn't be passing traffic with full channel setting, right?

Mike

I guess no response means it can't be done, or nobody is doing it? I should think the MT cards would do it easier than the XR cards, but am probably mistaken. If there is anything I should try, or more info I can supply please let me know.

Best Regards,

Mike

2 x 433 with R52N - v4.01rc1 XR2 cards in both routers are already running 1/4 channel and passing traffic fine. I have a link I'm building on which I would like to try a half channel. I have everything working, and the slave registers just fine and passes traffic when I use 20 MHz channel width. No...

Yes I am using winbox. I would like to look at other's configurations to learn. I am familiar with command line interfaces and they don't intimidate me. I would like to look how an experienced user configured a similar setup to mine: MT 433AH, wlan1, wlan2, ether1. I want to use one card for a point...

I have a couple new MT routers with 2 radio cards. I am configuring them to use wlan1 as a point-to-point, and wlan2 as an AP. I am new to MT and currently use Canopy, Deliberant and others in my network. I bought Dennis Burgess' book and have ben poring over the mT site. I am a very hands on, see i...