Nevermind,
I figured out that the MTU on the ethernet interfaces needed to be at least 1508.

--Christian

Hello, We are trying to transition from EoIP to VPLS tunnels. Having a VPLS MTU issue, not sure if my settings are correct. I have the following setup (see below.) When I try to do a speedtest through the tunnel it fails after it connects unless I set it to UDP and reduce the packet size down to 148...

How would one go about setting an EoIP tunnel src address? We'd like to have two tunnels going out the same ethernet but originating via different IP addresses for routing and prioritization purposes. I see that there is no setting on the interface, but is there a way via a virtual ethernet or vlan?...

Is it possible to display the board i.e. RB433 on a device in the dude if it is of type Router OS?

I haven't found anything for SNMP or functions that seem to point me in the right direction?

Thanks,
--Chris

Looks like when I closed and reopened the console it caused the links to appear. So maybe chaulk that up to a bug.

All is good,
--Christian

I have done that, I can see the data in the tooltip if I mouseover the link. I just can't see any label on the link. I checked the settings. And if I create a device to device link on the same map the label shows on the link. It is just when I have a submap to submap link that I can't show a label. ...

Hello, First, thanks for a great product, I am impressed. Keep up the good work. I have a question on how to show label information on submap to submap links. I can see the data via tooltips but I can't see a label on the link. Am I missing a setting somewhere to show that? I didn't customize the li...