Hi All I am having a very large HW Frame vs Frames rate difference on one of my PTP links and am wondering if this could be caused by alignment? I have noticed that the Rx Rate keeps fluctuating between 6Mbps and 300Mbps. The two devices (SXT 5nD r2) are quite close to each other so I had to turn do...

Hi All I currently have two AP's connected using HWMP+ mesh (More will be added later) however I am wanting to enable Nstreme to avoid hidden nodes etc, however when I enable it the link drops and the WDS never comes back up. I need to have clients connecting at both ends (SXT's) and the AP's to be ...

I have a similar requirement, did you ever come right with this? The http://www.demo.accessmanager.in/admin seems dead.

Hi I am connecting to Mikrotik devices together (RB433 and Groove 2.4), the Rb433 is setup in ap bridge mode while the Groove is setup as station mode. This connection works perfectly however I want clients to be able to connect tithe groove device also so I configured a VirtualAP, however clients ...

Hi I am connecting to Mikrotik devices together (RB433 and Groove 2.4), the Rb433 is setup in ap bridge mode while the Groove is setup as station mode. This connection works perfectly however I want clients to be able to connect tithe groove device also so I configured a VirtualAP, however clients a...

Hi

I am looking for a decent reasonably priced/free online Radius server that does accounting for my authentication as an alternative to User Manager, any suggestions?

Thanks

Sorry but a had misunderstood, this is very good result. Nothing for worry about it. Correct, you don't need to worry about it - it is a good result. Older legacy chipsets could have noise level approx up to -97, but new N chipset cards has better results and could go to above -100. So even if I fo...

The lower the 'noise floor', the better. Your 'noise floor' is not higher than 100 dBm, but lower than -100 dBm . Notice a minus sign in 'noise floor' value. HTH, Post corrected thanks. What I was told and am wanting to confirm is if a noise floor value is between -100dBm and -127dBm there is a pro...

I also have a groove 2 but the results with a 10dB omni are clearly better. Are the regional settings set correctly? and the bandweith Is possible the antenna not of good quality or there are too many disturbance factors outside. Maby try another antenna Sorry for my bad englisch Thanks for your as...

with what routerboarden and wireless cards do you work?

Hi

RouterBoard Groove 2A with 2.4GHz 12dBi Vertical Omni Antenna.

Thanks

Hi All I have installed a new AP in my area and am having poor signal to my other AP using WDS. I have done some digging and it my noise floor value on the card is sitting at -113dBm. People have mentioned to me this is usually caused by a wireless card or antenna fault, is this so? When I do a scan...

Hi My network layout is as follows: 10.0.0.0/24 (Hotspot) -> 192.168.0.0/24 (Lan) I need for all traffic to a 192.168.0.2 to be excluded from the accounting as users will be copying files from there and I don't want that to go towards their CAP. So far I have managed to set a rule on forward chain f...