What is soloution ?

My friend Second router with bgp with this problem.
https://www.youtube.com/watch?v=uhkxLCw ... e=youtu.be

I have got this problem also.
Coud you make support if ?
Could you fix it ?
Take a look on my movie.
https://www.youtube.com/watch?v=zY_COR92f0c

Hello Dude I have got mikrotik ccr CCR1016-12S-1S+ and some problems. I can not make support file it stops on 1% and ca not and dhcpd sererver by configurator (DHCP Setup - timeout (13) ( in web in ssh and winbox). I have checked diferent device but no luck. software 6.33.3. and lower also. But when...

Hello I upgraded my RB433 from 3.30 to 4.17>5.26>6.29 All went fine. But i noticed one problem. ETHER1 is making traffic (around 15mbs) all the time even if device connected to it is not making any traffic at all. When i disable it its OK then i enable and its OK until i try to ping something on th...

Hi
I have got router with 6.28 working fine 2 peers bgp and pppoe server.
After upgrading to 6.29 some pppoe clients are connecting and disconnecting.
Second problem is trafic on some sfp ports winbox shows the same traffic on few ports.

Hello I have got CCR1016-12S-1S+ router. Sometimes when i reset it do not start and on lcd screen only info load from nand... How can i do netinstall? loading kernel from nand... OK setting up elf image... OK jumping to kernel code (0,0) hv_panic: corrupt hvfs: computed CRC 0x3202b038, trailer CRC 0...

Hi dudes
I have got problem with booting my ccr with 6.25. After sending to device 6.25 firmware i reboot device and i had info on lcd about booting kernel from nand only.
I disconected device from power suplay and it works now.
Where was / is problem ?
Jakub

I have got rb1200 with soft 6.2.
After restart i can not see mrtg grafics is is clear.
I have got "store on disc" mode on.
What can i do ?