+1 for me on this too would like to see Ethernet OAM

The server is freeswitch and I have aggressive nat on so it makes the client reg every 30 sec.

I have changed all the internal sip port and it does work well now.

It is a pain though to have to manually set all the internal sip ports. Is this the only way?

I agree with this one

[admin@MikroTik] /ip firewall nat> print Flags: X - disabled, I - invalid, D - dynamic 0 ;;; default configuration chain=srcnat action=masquerade out-interface=ether1-gateway Very basic nat here just anything that goes out eth 1. My problem is why doesn't the NAT change the source port when it does ...

I have done lots of forum reading. My two choices are either to have every phone internaly use a different sip port or turn on sip AGL. What disavantage does sip AGL have?

I have a problem with NAT masquerade on a Mikrotik RB750. Here is the setup Server <----> Internet <-----> RB750 <------> Phones The phones that I am using are Cisco SPA942. All phones have the local sip port and remote sip port set as 5080. Here is the example IPs that I will be using for my exampl...

I have two router boards that I am trying to setup IPIP tunnels with IPsec running across with OSFP. I get the tunnels up and able to pass traffic. I am able to reach both sides of the tunnel and behind the routers too. The problem is that the SA are only installed and the remote peers connection sh...

Well I have since found out everything so I will post so if anyone runs across this they know what I know. I tried with three different products on ATT network. The first was a DataConnection plan which is a session based plan for Consumers. The settings for this was the APN has to be isp.cingular o...

I have a RB411UAHR with MC8705 that I am trying to setup with ATT 3G HSPA+ SIM card. Here is my device info and debug output. Not able to get the data to come up. Any help would be appreciated Thanks J

Device Info
http://pastebin.com/cwgyK20a

Log output
http://pastebin.com/u8HLv2Sp

I thought the same thing as there was some that was missing the imports but I then made sure that all them showed that missing imports had nothing. Still the trees don't show up on the tree tab.

Any other thoughts?

I am having a hard time with the MIB on The Dude 4.0beta3. I have loaded the following MIBs below but when I go to the tree I only see DLSW-MIB0 -- 1, IEEE8021-PAE-MIB -- 110, IEEE8023-LAB-MIB -- 85, and IEEE802dot11-MIB --218. All of the other ones are grayed out and I don't see them in the tree. W...

Ok here is a update. All attempts so far has been from the 750 to Cisco.... If I go from cisco to 750 it work great here is the cisco log Group = 68.109.sss.xxx, IP = 68.109.xxx.xxx, PHASE 1 COMPLETED Group = 68.109.xxx.xxx, IP = 68.109.xxx.xxx, Security negotiation complete for LAN-to-LAN Group (68...

I have set it up like described in this guide http://wiki.mikrotik.com/wiki/MikroTik_router_to_CISCO_PIX_Firewall_IPSEC As I know that is a pic there is slight differences but this is the problem I have. The 750 never even tries to make a connection to the cisco. The logs show no attempt. Below is m...