Just adding my two cents to this oldish thread for posterity: I too had issue with Policy Based Routing (routing marks) and missing packets. I have setup 2 voip phones on my local connection, with an LT2P VPN tunnel to a remote location where the PBX is. I then initiated a call between the two local...

@samsung172: What is the significance of 1280? I've been having MTU issues trying to bridge a network over L2TP using BCP as described here(*1) I have had tons of errors. Your advice helped me - I can now load pages from our web server at the other end of the tunnel, although there are still a few e...

Guys - can you check and tell me if: a) In your Firewall -> Mangle rules, your PPPoE connections have properly created the dynamic change MSS actions? This is the default if you are using the "default" profile under PPP and of course, you didn't change the "Change TCP MSS" to som...

Whenever you have multiple policies with a Cisco device you need to set your policy level to unique.

Can you explain why this is?

Thanks,

-Rob

OK gang, Not getting any bites on this, so here is a picture and video to help stimulate some conversation! :) I've attached a network diagram to this post and I've also added a DEMO VIDEO you can download from HERE . I'm hoping the above information (which has also been sent to MT support) will be ...

Hi, I have the IPSEC VPN server setup as per the wiki with two dynamic Routerboard clients (clients with dynamic IPs) connecting back to the router. If either one by themselves connect, things are fine. If I enable both Peer profiles (both having their address set to 0.0.0.0/0) only one of them succ...

The problem seems to be related to static IP assigned by the ISP to to router. Since its the same IP each time the PPPoE session is negotiated, the address does not appear to be cleared from the Dynamic address table and this is causing the error. I've tested this on a dynamic address and non-PPPoE ...

Hi, I've sent in a request to support a week or so ago and was told to upgrade from 5.15 to 5.16 and try again. Which I did, and still had the same problem: I have a RB750GL that is using PPPoE to connect to the internet. I've configured OpenVPN Server on the same RB. I then try and connect from a r...

Hi! I'm trying to figure out the best way to apply QOS to traffic both within an IPSEC tunnel to another site, as well as to general outbound Internet traffic. I've got a good handle on the Internet traffic, but I'm not sure how to tame the various types of traffic going through the IPSEC tunnel. Sh...

I just thought I'd chime in with my findings, since I had spent numerous hours getting this unit to work with my new OmniTik router: I received a brand new Rogers ZTE MF668 rocket stick yesterday to replace my old Novatel MC950D that I've had for a few years and also had working with the OmniTik. Fi...