Hello again, to make it more understandable i need to tell my mikrotik router that if ovpn client1 tries to connect to the public ip 10.1.1.1 with port 1198 to take it through the gateway of wan1 if ovpn client2 tries to connect to the same public ip 10.1.1.1 with port 1200 to take it through the ga...

Thank you for the reply, The problem is that the ovpn Servers run on the same machine (they have the same public ip address, but listen to different ports). The idea is that ovpn client1 in rb450g to connect to openvpn server1 through wan1 and also ovpn client2 to connect to ovpn server2 through wan...

Hello everybody,

We have a rb450g and we have created two ovpn client interfaces:
ovpn1
ovpn2

we have also two wan interfaces:
wan1
wan2

we need ovpn1 to connect to the ovpnserver through wan1, and ovpn2 through wan2.

Thank you.

Hello everyone , We would like to know if the following setup will work, assume that we connect 4 adsl on the routerboard rb450 using pppoe client for each one of them. the provider is giving the same gateway for each adsl. is it possible to have more than one pppoe connected using the same gateway?...

hello again.
this happened due to a misconfiguration on RADIUS server.
so please ignore previous post.

Hello again , I managed to connect my openvpn client to my openvpn server and have access on the lan side of my openvpn server, so does the openvpn server to the lan side of openvpn client, the issue is that when i create a radius client on my rb450 which is also my openvpn client it cant seem to pa...

In mangle output chain mark-routing for tcp/1194 traffic add route in routing table with this routing mark to reoute over gateway2. In main routing table add route to route over gateway1 for fallback if gw2 fails. thank u mrz for your reply, can u please send me the command lines , i am having diff...

Are you establishing OVPN connection from the router or from the client PC behind the router?

my openvpn client is a rb450g and my openvpn server is rb1100

Thank u Dobby for your reply. I checked the links and i have done the same configuration. Again i am trying to say that loadbalancing works fine , the issue is with openvpn connection passing through that loadbalancing. i have connection with my openvpn server but my loadbalancing rules wont let me ...

Hello everybody, I have configured load balancing on my rb 450g and it works fine , the thing is that when i establish an openvpn connection, even though my openvpn client is connected to my openvpn server, my load balancing rules are not allowing me to commune with the lan side of the openvpn serve...

i have the same problem , i cant polycom 8440 with mikrotik rb411 even if the wmm is enabled..

any suggestions?

I have the same problem with cisco wip310 & miktorik rb411 , they can hear me i cant hear them , with other access point i dont have any problem , i think i will replace all my mikrotik access points, this is very annoying...