I have upgraded my RB800 board to 6.1 OS. Link distance is 16km. Bandwidth is 60/60Mb with stable data rate locked at 180/180Mbps.CCQ 100/98%. However,i cannot able to configure custom channel width. Below is error msg. I have understood from MUM presentation that you can bond 30Mhz custom channel w...

Steps.. 1) Make 2 P2P transparent Link. 2) Create bonding interface and add the 2 Ethernet interface of the link. http://wiki.mikrotik.com/wiki/Manual:Bonding_Examples 3) Assign IP address to each bonding interface. 4) Select ARP monitoring and under the target ip , assign the bonding interface ip o...

Dbii F50N Pro.

Alfa Cable from Alfa Network.

http://www.rts-wireless.com/Cables_Pigt ... _0_3m.html

Manually i put 46km (Google Earth measurement) but it comes 44km.

After upgrading 5.15. CCQ is very stable. On 40Mhz i got 90Mbps total link capacity.

Version:5.14.

WDS with NV2.

F50N Pro card from Dbii.

Regards,

Jaweed Patel.

Hi All,

Below is test result of P2P link working on Nv2. Live traffic is moving 60 Mbps and i added 20Mbps more.

UBNT 34dBi Dish with RB800.

Regards,

Jaweed Patel.

I changed Nv2 to Nstream. Result is very poor. Normal ping is 1ms.

but when i try to put 5Mb of load CCQ start jumping from 90 range to 25-35. and some times it disconnect.

What i have noticed is that from AP side RX CCQ is very stable. It remains 100% but tx CCQ drops to 20 and than it disconnect.

Sorry for delay reply, because of the time difference.

I have installed below hardware.

34dBi UBNT dish, RB433AH and Alfa cable.

Nv2 over 20Mhz.

Sometimes during the day signal fluctuate from 44 to 60, this is because the link travels over the sea.

Hi All,

We have installed 46 km P2P wireless link. 80 % of the link goes above the red sea (Saudi Arabia). With different modulation(HT MCS) we got below link result.

Guys,

I need your assistance.

Regards,

JP

Hi Everyone, I want to get maximum bandwidth between two locations. I have installed 2 Ubiquiti point to point transparent wireless bridge. Each carrying 30/30Mbps traffic. My Requirement: Each P2P link should carry one VPLS tunnel and bonds this two vpls tunnels together. Eg. P2P Link 1 tunnel id 1...