That seems simple enough. I will do some more reading and order my new equipment. Thanks for pointing me in the right direction.
Lyle

Sorry I didn't get back to you. I was away. I actually don't need help anymore. I thought maybe I was having IP conflicts with my new system. It turns out the new UBNT rocket M2's didn't want to work properly with my older Engenious EOC1650 cpe's. It would work just fine then all of a sudden every m...

I currently have my internet connection from a local provider. It is plugged into ether1 on my routerboard. I now have the opportunity to use a friends connection. It is double the download speed and quadruple the upload. I am thinking of purchasing a couple UBNT NanoBridge M5-22. to link to him abo...

Hello. I am needing some help here. I just recently set up my routerboard running version 6.5. My isp router has an address of 192.168.1. and gives addresses by dhcp. Connected to my routerboard are three ubnt rocket m2. They are on channel 1 6 and 11. The performance is very flaky. routerboard ip =...

I connected again to the south ap. Works now a little. Getting a 1mb connection. I then created a virtual ap on the same ap. Now working perfect with a 36mb connection. What is going on?

I have a routerboard 435g running three xr2. They are running ap bridge mode on chanel 1 6 and 11. I have linksys running ddwrt that was working just fine connected to the south facing ap. A while ago i had to start doing reboots to bring the connection back up. Now it will not connect to the south ...

I have a question about setting up a static route. I have a router connected in client mode to to the routerboard. I need to log into it and cannot get the route set up. It was handed an IP of 192.168.2.245 and its local ip is 192.168.138.101.
What destination address and gateway do I use?
Thanks
Lyle

Sorry for the late reply. I got it up and running and posted that it worked. For some reason my post never showed up on the forum.
Thanks
Lyle

I am guessing I need addresses in ip>addresses. I only see the default on eth1 of 192.168.88.1 and cannot figure out or find the documentation on this.

I am using the setup wizard. Ip>Dhcp sercer>dhcp setup. Using webfig v5.2 . There are no defaults showing up. DHCP Address Space shows 0.0.0.0/0. I input 192.168.0.0/24 for this. and 192.168.0.1 for gateway and relay show up. 192.168.0.2-192.168.0.254 shows up as well. Still no dhcp on eth2 and wlan...

I am having a lot of trouble with this. My router is has default ip of 192.168.88.1 . I have eth2 and wlan1 bridged on bridge1. I am setting up dhcp server on bridge1. What should I set DHCP Address Space to? Gateway for DHCP Network? DHCP Relay? Obviously I am doing something wrong. Thanks "gi...

I had them bridged at first and applied the server to the bridge. When this did not work I did a complete reset and tried eth2 and wlan1 with dchp server and no bridges. Right now there are no ports in the bridge. Is there an easy way to send you my configuration. I still have a lot to learn. I usua...

Hello. I just unwrapped my new routerboad 435g yesterday. I have managed to get everything working except the dhcp server. Not on eth2 or wlan1. I have read the manual and this does not seem to work for me. Please help, I have spent all afternoon trying to figure what I have done wrong.
Thanks