I have strange problem since 6.9 (also in 6.13, 6.14) If more than 3000 simple queues on CCR1016 - www graphing does not work. If I delete some queues... for example there will be 2990 - www graphing is working. Could you fix that? I`ve check this on other CCR - 1036, the same problem. Obviously so...

Today I had ddos attack from ipv6 addresses. In address list have at src-address is attacks addresses. Firewall filters have rule: 0 chain=forward action=drop protocol=udp src-address-list=ddosers 1 chain=forward action=drop protocol=tcp src-address-list=ddosers 4 chain=forward action=jump jump-targ...

Hello I have problem with simple queues I have global queue main and 2 sub queues with services: 1. services1 - whith piorytety 6 2. services2 - whith piorytety 5 But working only 1 sub queuer. Example when working service1: main | |--services1 | | | |--http | |--ftp | |--smtp | | |--services2 | |-s...

ROS 5.23 and ROS 5.24 start problem with protocol ssh in mpls , when is used pptp.


H1----R1--(MPLS)---R2--(MPLS)---R3---(MPLS over pptp)--R4---H2

Host H1 can't connect to host H2 used ssh.

Hi
Are there plans to add support for rule (new-vlan-id) for the Atheros 8327 chip switch?

Does anyone know?

http://wiki.mikrotik.com/wiki/Manual:Sw ... p_Features

Does anyone have the same problem with the RIPng? So instead of connections, type "connect" are seen by the router "R2" as RIPng. After turning off the router "R3" router "R2" loses network routing table, which wrong seen as "RIPng" but should it be ...

Problem with routing protocol RIPng after shutdown another router. AP | |---Host1 | R3-------R2-(eth5,eth3,eth2)------------R1(gateway) | |(Vlan5,Vlan6 on eth4) | Host2 [admin@R2] > /interface ethernet print Flags: X - disabled, R - running, S - slave # NAME MTU MAC-ADDRESS ARP MASTER-PORT SWITCH 0 ...