I have no problem connecting my Linksys WRT54GSv4 to MikroTik 2.9.38 with PPPoE Server setup.

Yes, it does, I am have a site that is running PPPoE over Wireless (2.4GHz and 5.7GHz)

Hi all,

I had setup the MikroTik Hotspot successfully. How do I enable unauthenticated users to ping the gateway?

Regards,
rootlinux

Hi all,

I have a current setup like below: -

Laptop (road warrior) <-- PPTP_VPN --> PPTP_VPN_SERVER <--> MikroTik (with PPPoE server config) <--> INTERNET

I cannot connect to MikroTik's PPPoE server with the above setup. Why?

Regards,
rootlinux

Thanks for your info... too bad... i need that too...

So, it this fixed in 2.9.37? I am having 2.9.35 with PPPoE too...going to launch our PPPoE service via wireless too,

How can I apply the following commands (used in Linux) in MikroTik?
route add -host 10.7.2.33 eth0
route add default gw 10.7.2.33

why u want to use the DHCP server ip addresses?

I am running a SBC. I have a 12 PCI slot backplane. I had installed 10 standalone PCI network cards. Total network cards I have is 11 in the system.

So, how many NIC can MikroTik 2.9.29 support?

The MikroTik can see only 10 nics... why?

You can solve this in the FreeRADIUS Simultaneous-Use...

Thanks for the info...

Dear all,

Does anybody here try installing MikroTik into a Embedded Disk Card?

The Embedded Disk Card info can be found at the URL below: -
http://www.anewtech.net/products_subsub ... roduct=115

Problem solved

I managed to install MikroTik 2.9.26 into a CF card using the CD.

I got this: -

LABEL linux
KERNEL linux
APPEND load_ramdisk=1 initrd=initrd.rgz -hdd-install

I had download the MikroTik 2.9.26 CF image. I used the PhysDiskWrite to write the CF image into the CF card via a USB card reader. I put in the CF card into server with built-in CF adapter, when it boot up, it shows the the MikroTik installation instead of booting up the whole system. Am I doing so...

I successfully write MikroTik 2.9.26 CF img into the CF card but when I boot from the CF, it shows installation...

How can I install from a CF to the same CF????

Can I do an installation from the CD Image to the CF card?

I can't find it in the docs...I just follow the default "op" value

Hi all, I have a server with RouterOS 2.9.24 using PPPoE and another server with FreeRADIUS and MySQL. All the setup in RouterOS 2.9.24 (24hrs limit) using PPPoE is OK. I have the following setting in the MySQL db: - mysql> select * from radcheck; +----+------------+---------------+----+----------+ ...