I have a RB2011 that does not respond anymore after I configured vrrp I tried to reset it but noticed that the reset button is broken off (open the case, reset button is broken off) Is there any other wat to reset it to factory defaults or is it bricked notice to mikrotik: please don't make the rese...

You should not have to use a bridge. Are you sure that the switch is configured correctly?

will check my switch config again

thx

I"m trying a simple setup port 2 of the CCR is connected to a switch that is configured as 802.1q trunk with several vlan on the CCR is made a number of vlan interfaces, configured ip address for each vlan interface and applied vlan interface to port 2 I connect a laptop to the same switch that...

got it working like this [admin@MikroTik] /system script> print Flags: I - invalid 0 name="priority-low" owner="admin" policy=read,write last-started=apr/09/2013 12:04:30 run-count=34 source=/interface vrrp set priority=80 [find name=vrrp1] 1 name="priority-high" owner=...

I'm trying to do some basic scripting. I want to set the vrrp priority based on the status of a netwatch. It doesn't seem to work, tried different things. When I run the script manually it ask me for "numbers" [admin@MikroTik] /system script> /tool netwatch print detail Flags: X - disabled...

maybe I'm blind but where is the reset button located? I can not find anything labeled "reset". The manual talks about this reset button.
It's the desktop model

Realistically, what kind of performance can I expect today?
Stability is more important for me today then raw numbers, I don't expect it to push several Gbit today, a few 100 Mbit would be fine, as long as it's stable
Is this realistic?

Thx for any feedback

I'm looking to use a couple of CCR1016-12G as an internet edge router. I'm following this thread and it seems that are still quite some bugs to be worked out. I don't need fancy features, just the usual stuff (full bgp peering, routing, some ACL rules for security, snmp for monitoring, maybe NAT). I...