thanks, will check. Here's my 'cleaned up' script. It is saved onto the Mikrotik, so it actually includes instructions for future me in years from now. # 1970-01-02 05:09:45 by RouterOS 7.11.3 # # model = RB5009UG+S+ # # # THIS IS NOT SECURED # -------------------- # only use when using an up-stream...

Well, finally got something working ..... :) I brought in a bunch of Raspberry PI's to set them up because I can change THOSE ip addresses to test jaclaz's solution. And it works fine. Been trying to convert them over to the ip addresses I need, but typo's being typo's haven't got it done yet. I'll ...

Got hit hard with snow - company shutdown for a few days. So, I haven't given up. I still need to talk to someone about outsourcing this, but snow emergencies.... It appears that 'routing-mark' isn't supported anymore in 'ip route'. /ip route add distance=1 dst-address=10.1.1.0/24 gateway=ether2 rou...

..... That's all there is to it :-) ..... If you can't find someone locally, I'm willing to consult with you, and replicate your setup, etc. and send you a tested/labbed configuration. Let me check on Monday. A few billable hours may not be a problem. I had a sense the VRF stuff was going to peek u...

Describe the problem. Fully!!! Sorry if I'm not clear. I'm trying to make the situation simple. Try this, assume you have 7 devices for which you can not change the IP address and they all have the same IP address, in this case 192.168.10.100. Now, each device is connected to a single physical inte...

yes. This is an industrial control system. Most of the hardware have embedded ip addresses that can only be changed to 1 of 4 available addresses. Regardless, they are all on 192.168.10.x. We don't allow external network connections, it would be a violation of meeting minimum spec, if anything goes ...

We bought tons of old MikroTik routers running RouterOS 4.14. These had 3 ports and we used 1 for admin and the other two for routing. I now have the RB5009UG+S+ running RouterOS 7.11.3 We have systems that are all configured at 192.168.10.100 and we used IP Firewall Filters to do nat-dst and nat-sr...

RESOLVED --- well, sort of... After several days of searching with google, I've got this article: http://wiki.mikrotik.com/wiki/How_to_configure_a_home_router which got me up and going. Even though I followed the article, (and if you do, too), I'm going to change my ports around so that my ISP facin...

Yea for NetInstall. Brought my board back to life. Gave up, yet again. It is clear that Mikrotik will never be a consumer product. We use them at work to srcnat/dstnat systems we are building, as each system has the same set of IP's, and we can put them on the network so I don't have to walk down to...

Thanks!

I've downgraded to 5.24 (I think, anyway the last 5.xx) because of confirmed issues with DHCP Client.

Then, I made a stupid mistake, lost access, tried to reboot with a reset configuration, and now I'm stuck at "Kernel Loading"......

I think I killed it.

--Ken

I'm having on tough time setting up my home network. You'd think it is easy. I have 6.0rc14 on a FB2011UAS-2HnD. 1. I want it to run my home network on 192.168.3.x. 2. use my provider ISP via DHCP client. 3. Serve up local IP's to a DHCP server 4. Run a WLAN Access Point. I set ether1 to a dhcp clie...