Can't do. Ruter is already sold. Why you can't it's easy to do? I think this use that part for solder or install for two external antennas left and right. I will try to do it for my RB951Ui-2HnD. Then I post new subject for my test to know how to do that. http://www.almafia.com/vb/up/1_01398562622....

Can't do. Ruter is already sold. Why you can't it's easy to do? I think this use that part for solder or install for two external antennas left and right. I will try to do it for my RB951Ui-2HnD. Then I post new subject for my test to know how to do that. http://www.almafia.com/vb/up/1_01398562622....

Hello, Also i had issue, where the signal and CCQ where ok but the tx/rx levels where not - "final" alligment of sextants solves the problem. And again doublecheck that both! ends are configured correctly HT chains and Channel width 20/40 (not 20)! Aleksander I try to change it all freque...

Hello, Also i had issue, where the signal and CCQ where ok but the tx/rx levels where not - "final" alligment of sextants solves the problem. And again doublecheck that both! ends are configured correctly HT chains and Channel width 20/40 (not 20)! Aleksander I try to change it all freque...

Hello,

180/180 are not good TX/RX levels for expected results! Under wireless card HT tab pay attention that both chains are enabled! By default they are not.

Kind Regards

Aleksander

I know my bro this is not good,

This HT are both the pic.

Hello, TX/RX levels are shown under radios registration tab. If you are allowed, you can try to set the superchannel mode to test different frequency ~4900-6100 and set the station side also to superchannel and scanlist according to your needs. Aleksander Hi This one you mean TX/RX levels http://ww...

Hello, And what are the TX/RX levels ? Try to change frequency till you get 300/300 Aleksander Hello, Where find this TX/RX levels can be give me this step? the frequency support I have ( 5180, 5200, 5220, 5240, 5260, 5280, 5300, 5320, 5745, 5765, 5785, 5805, 5825) I try to change the frequency's a...

This is from client point



This with SpeedTest



Thanks

I have some pictures

Client Point




Bandwidth Test (RECEIVE) From Client Point




Bandwidth Test (SEND) From Client Point

Hello, Just throughput in bridged mode is not related to the license level. You have to tune your radio to take out the maximum. Trie to set the ap to the 5G only N 20/40Mhz nv2-nstream and the other side station-wds or station bridge also with 5G only N and 20/40Mhz and protocol all. Look athe sig...

Hello, I have two of SEXTANT G 5HPnD - Point 2 Point.. Is it possible to transport support to 26 MB/s real transfer I mean 200MB/s Upload & Download Speed P2P (200MB's Speed [ 1024kb*200mb=204800b/8=25.6MB's ] real transfer) with Level 4 or need to upgrade to up level 5 or 6 to support the speed...