Thanks all. I managed to get /56 from ISP and now all is good.
I'll look into a single bridge with VLAN some day.

I am trying to setup IPv6 with only a /64 assigned to me from ISP and 4 segregated bridges on my network. Quite new to IPv6 so not sure what is the correct solution. What is the proper way to do so? If I set each of the router address for each of the bridge to be /64, the computers wont router traff...

Thanks for all the help everyone. Quick update for folks interested.

I managed to get an exact model on the same version and firmware. Used the same configuration and there was no issue.
Seems like it is the hardware going bad.

Replaced with RB4011 and not having any issue now.

Thank you all!

I made the changes for that already and it didnt make any difference - still getting packet loss. I tried eliminating all config related issues through doing the factory reset and using the default config. The only change I made was disable wireless and change admin password. I still get packet loss...

Switched out the capacitors. Still getting packet loss.
Any other ideas as to where I should look?

Ahh. I guess that's what I'll do.

It is sitting open in an open room on a table/shelf. System/Health reports temps of around 21C. Been using the router for 7 years.
Time to source some capacitors then.

Thanks - I'll reach out to Mikrotik support I am starting to think it is a hardware issue. I did a factory reset with a fresh install of v6.47.9 via Netinstall without any config changes and I still got packet loss. Curious - I know that capacitors are a common issue. I checked the voltages on those...

Did the downgrade back to 6.47.9 and updated RouterBOOt - still getting ping loss

Thank you for the feedback on the config. I have made the changes and I am still seeing drop packets. It definitely seems like any packet going to the Atheros chip on Port 1 - 5 is having packet drops in this case. Are there any other config changes that might be able to resolve the issue? Or does t...

To your first point, this is my logic to check that it is not a cable, device or switch issue. See network diagram PC-1 to Router (Port 3) - Packet loss PC-2 to Router (Port 3) - Packet loss PC-2 to PC-1 - No packet loss PC-3 to Router (Port 2) - Packet loss Raspberry Pi to Router (Port 4) - Packet ...

Looking for help with some packet loss issue I am experience. I don't think I experienced it previously so it is a new issue. Situation - Getting <= 1% packet loss when pinging from devices (e.g. 192.168.1.100) to router IP (192.168.1.1) - Tried isolating the problem and it seems to be happening on ...

I am currently running OpenVPN on a Mikrotik router to enable myself to connect from an external network to my home network. However, the current OpenVPN implementation does not support UDP, MFA and SHA256, which I am hoping to use. As such, I am looking to install OpenVPN on a Raspberypi server on ...

I think I have found my solution. Since the client site has a DNS, I was able to use a script to update the client site IP to an address-list that would be allowed through the firewall. Inherently, I dont trust my ability to configure IPSec to the point that there are no vulnerability. So I want a s...

Thanks sindy. I added the two filter, but I modified the input filter to drop everything except for the src-ip where I expect it to be coming from. Seems like only the input chain filter is increasing, pointing to an external connection attempt (around 131 packets dropped). After getting the dropped...

It seems recently I have been getting a lot of IPSec errors. Currently, IPSec is only used for a PPP tunnel between two MikroTik sites. Looking at the log it seems to be trying to make a connection to an IP address in Japan. The address is not one that I recognize or within my local vicinity. The er...

I am having issues where wireless stops working after working for a few days of operation. Background: - Have been using the existing configuration for ~2 years - Most recent change is the package update to 6.40.5 to fix KRACK vulnerability - RB2011UiAS-2HnD-IN Problem: - Issue seems to have started...

Hello all, Just moved to a 2011UiAS-2HnD from an old ASUS RT-N16 on DD-WRT. Must say I am loving it so far. Managed to setup most of the stuff I want. Currently trying to setup OpenVPN on my router as a server, but running into some issues. Would greatly appreciate it if someone can point me in the ...