yes thats was added and disabled

Strangly enough half of this seems to have fixed it Check under interface --> bridge --> port and check if ether6 has been added tot he list. If ether 1 is there then remove that one and repalce with ether6 Also check if ether1 had ip address assigned to it and change it to ether 6 Although Eth1 was...

The firewall responds to a ping from the Internet, Packet trace is done on the firewall external interface.

Is the mac address of your firewall visible in /interface bridge host print? YES Is the mac address and IP address of the firewall visible in /ip arp print? YES Is the firewall anyhow accessible (for example by ping, if it answers ICMP probes) from your LAN subnet (217.x.x.32/29) or from the interne...

Yes Internet Access is fine

Yes thats correct, PPPOE has got a DHCP address from the ISP of 81.x.x.x and Eth 4 isin a bridge with IP Address 217.x.x.38/255.255.255.248 which is my router address. C - connect, S - static, r - rip, b - bgp, o - ospf, m - mme, B - blackhole, U - unreachable, P - prohibit # DST-ADDRESS PREF-SRC GA...

Hi, I have a mikrotik B2011 plugged in to my BT infinity Modem, Port ether6 connects PPPOE and ether 4 is my firewall. PPPOE gets DHCP from network and my devices have static IP's assigned. We have a site to site VPN which will not come up, it worked when I used port ether1 but I had speed issues wi...

Hi, I have a Mikrotik B2011 which I am using on my BT Infinity Broadband. I have the BT modem plugged in to ether6 with PPPOE set up and the Two Devices (Both Firewalls) programmed with Static IP addresses plugged in also and the ports are bridged. One of the Plugged in devices is a Juniper SRX whic...