You can use One static route with 2 different Gateway (such as Router 1 and Router 2) for each Master Router and use "Check-Gateway" option for pinging Gateway , when down one gateway , Mikrotik Automatically so witch to other Router. and another way is using tow Different Static Route wit...

Because you connect a device to one port have VLAN and your Access-point don't understand VLAN ! so you can use a another router for get traffic on VLAN and then set ip address on Input port and connect your AP to other port !

yes it is possible easily . first : i dont know your router device model ! but usually you can run MikroTik User-Manager for create your user (Use it as Radius Server) then you can easily limit RX/TX ban-rate and Limit Download Traffic for each user per month or day.(dont mater you use PPTP Service ...

so you can create new VPN Connection to your PC or Laptop and test it in your LAN(Connect to ether1 port of your router directly), and check it ! are you can connect to your VPN Server(Router) ?

yes you can do it easily by some route command. first step unchecked your Default Route from your PPTP Connection on your router then add default route for your Internet Access with your PPTP Connection and set Distance greater than 2 , and after create route for internet access you must create othe...

HI
you can easily run setup for creating Accee Point mode in your RB433 with your Minicard and Antenna then setup HOTSPOT on your WLAN Interface for Authentication .

HI yes you can. you must connect your local interface to one port of your Router such as ether2 and your Input Internet (send to you from CISCO Router) to ether1 port on your Router.Than add new DHCP-CLIENT to your router for ether1 then add new route "/ip route add gateway=your CISCO Address&q...

HI you can easily solve this problem without special Scripts. you can have tow VPN Connection activate synchronously and have 2 Default route or any route for your destination but one for your General port and other route for your 4G Interface . The 4G Route must have distance Greater than distance ...

Are you have Valid IP Address in each side routers ? if you have tow IP Valid in each router you can easily run EOIP Tunnel and have a Layer 2 Connection ! but if you dont have IP Valid in each Router , you can easily set PPTP Server Enable in your Router(must have Valid IP address for Transport you...