OK here is the update, I drive the 2 hrs to get there again so first I think I will hook up my laptop straight in and see, so I did I get 176x9, so I thinking something is going on. I brought another CCR1009 and just did a base config on it and got about the same numbers, I go out and test it on the...

I checked and enabled the half modes , didn't help but I went back and disabled the gigabit and went with 100 and it worked a little better I didn't get disconnected but it wasn't any faster.

Well I am going to say it must be something on site, I have another one of those routers here and tested it and don't have any issues so I am going to have to make another site visit and see.
Thanks

Well I did this to the firewall rules and I still have the same speed, when I run the speedtest it is odd , I am connected remotely and it times out my connection to the router with winbox and my RDP connection but only is getting 12Mbit , when i use btest I can see 972. Even though the ASA was only...

I am using the ether1 interface for the outside to the world and ether2 for the inside network. I first started with the quickset option and just used NAT option. since then I have added some queues to handle VoIP and such to try to help out but I havent heard if that has helped the phone problem or...

Hi, I have looked for possible routing issues but this one kind of stumps me here is the setup. Client had an ASA5505 , ISP gave them a gigabit link (1Gx11M), when I arrived I tested with the old hardware to say speedtest and they get about 80Mbit down. I install the new piece of hardware(CCR1009-7G...

Ya know it is funny, I searched and searched (or so I thought) and as soon as i ask for help, a few hours later I find that info in the wiki and it works fine, just imported my certs and such, sorry not looking better.
Thanks
Jarrid

I current have a working setup but my main router is a linux box and I want to convert it to my rb750, the clients use certificates to connect and I was wondering if I was able to import the server certs and pem and such but I don't see if there is way or how to make entries for the clients or do I ...

Well I don't understand I have redone the setups 5 times on both ends and it works fine, just like it should have the first time. Here is a little back ground of this test. Normally I would not have access to anything on the remote end so until I test in the field I will have assume that it will wor...

Thanks for you input, I did actually get it working today, saved the config started both ends fresh and did what I thought I had done and didnt work but I think what it was is the order they are in the firewall list. I will put the config up when I get it for sure, the bad thing is it was one of tho...

I hate to whip up an old thread but maybe there are some new eyes out there. I had already done what was described in the last post, I have set up many of the setups with ASAs already but wanted to try a much cheaper alternative. I can get this to work to a point, while you do have to do a srcnat an...